How do you change a front axle shaft?
To change a front axle shaft, you would require following tools Jack and support the car properly. By doing this, you will be able to diagnose any problems with the joints. This can be done by turning the wheel slowly, with your hands. Hold on to the shaft’s metal part situated between the joints.
What’s the best way to replace a strut?
Once it’s in place, torque the strut mount nuts to spec. Then push the steering knuckle into the strut flange and use a pin punch to align one hole so you can insert a bolt. Then remove the punch and insert the other bolt. Snug up the nuts, but don’t tighten fully.
How do you replace a CV axle in a car?
You can remove the band from the inner boot to help the old axle pass through. Insert the new CV axle into the transmission housing. Just as you removed the old CV axle, insert the new one into the same spot in the transmission housing. The peg will slide all the way in until the axle is flush against the housing.
Can a wheel hub be removed from a strut?
Unbolt the hub from the strut tower. Two more 17mm bolts will connect the wheel hub to the strut tower. Once you remove these bolts, the hub should only be connected by the axle through the center hole, and you should easily be able to remove it.
How to install or replace front struts on any vehicle?
How to Install or Replace Front Struts on Any Vehicle! (Full Guide!) – YouTube How to Install or Replace Front Struts on Any Vehicle! (Full Guide!) If playback doesn’t begin shortly, try restarting your device. Videos you watch may be added to the TV’s watch history and influence TV recommendations.
What’s the best way to change an axle?
By this time, you can put the wheel back on the vehicle (again, the same as you would when changing a tire). After the wheel is on, you can lower the car off the jack and jack stands. Tighten the axle nut. Finally, you can retighten the axle nut once the vehicle is back on the ground.
You can remove the band from the inner boot to help the old axle pass through. Insert the new CV axle into the transmission housing. Just as you removed the old CV axle, insert the new one into the same spot in the transmission housing. The peg will slide all the way in until the axle is flush against the housing.
When do you replace the front axle on a Chevy Silverado?
In this video, we’re going to show you how to replace the right hand, or passenger side, front axle on this 2011 Chevy Silverado. This is a 1500. The procedure for the left axle is pretty much the same, and it’s also the same for these trucks for model years 2007-2013 for both this Chevy Silverado 1500, as well as the GMC Sierra.