How to reset the fault code for the camshaft?
1 Resetting the fault codes and performing a road test 2 Changing the oil and filter to the proper oil viscosity for the engine specifications 3 Repairing or replacing the wiring to the camshaft oil control valve for bank 1 intake camshaft 4 Replacing the camshaft oil control valve for bank 1 intake camshaft
What should I do if my camshaft position sensor is not working?
If you find that the camshaft position sensor fails to produce a voltage or a signal, remove it and check the reluctor ring for damage, debris, or misalignment. If the reluctor ring appears in good condition, replace the camshaft position sensor.
What is the diagnostic code for camshaft position a?
P0011 is a diagnostic trouble code (DTC) for “Camshaft Position A – Timing Over-Advanced or System Performance (Bank 1)”.
What to do if your camshaft has trouble code p0340?
Make any other repairs (if other codes are present) to make sure that other codes are not sources of the trouble code P0340. Check your camshaft position sensor’s voltage, ground, and signal readings with a multimeter. Check out this video for a visual reference on how to check it using your multimeter.
What does check engine light mean on Nissan Xterra?
A check engine light can indicate a broad spectrum of problems with your 2011 Nissan Xterra. In some cases you need to pull over immediately to prevent damage while in others you merely need to tighten you gas cap next time you stop in order to reset the service engine soon light.
What is the trouble code for camshaft position a?
P0011 OBD-II Trouble Code: Camshaft Position A – Timing Over-Advanced or System Performance (Bank 1) Cost of diagnosing the P0011 code. P0011 is a diagnostic trouble code (DTC) for “Camshaft Position A – Timing Over-Advanced or System Performance (Bank 1)”.
What to do if your camshaft position sensor says p0340?
Visually inspect the camshaft position sensor connector in search of corroded or broken connectors. Make any other repairs (if other codes are present) to make sure that other codes are not sources of the trouble code P0340. Check your camshaft position sensor’s voltage, ground, and signal readings with a multimeter.
Where is the camshaft position sensor located in a car?
The camshaft position sensor located in the internal combustion engine monitors the position and rotational speed of the camshaft. It works hand in hand with the reluctor ring that creates a square wave voltage signal that the ECM interprets as the crankshaft position.