How do you open the back door on a 2005 Nissan Sentra?
When you open the trunk, there should be a knob at the top right of the opening. Pull that and it will unlock the locking mechanism for the rear seats.
Is Nissan Sentra roomy?
With 14.3 cubic feet of space, the Sentra’s trunk provides less room than that of many other compact cars. The wide opening is a plus, but the folded rear seats sit a few inches higher than the trunk floor, which can make it hard to load long items.
Can I fit a 75 TV in my car?
A 75 inch TV will fit inside the back of your minivan without any issue no matter if you are transporting it on its side or standing up (as recommended by the manufacturers). You will have to turn it at an angle as it goes through the rear door and then you simply have to set it back upright or lay it flat once inside.
How to remove the rear seat on a Nissan Sentra?
Tighten the rear seatback assembly bolts to specification. Refer to SE-22, “Exploded View”. Place the rear seatback assembly (LH) in the folded down position. Release the J-hook retainer (A) and unzip the seatback trim zippers (B). Remove two nuts (A) and the armrest assembly. Installation is in the reverse order of removal.
How to remove the bolster from a Nissan Sentra?
Removal and Installation – Rear Seat Bolster REMOVAL Remove the seat cushion assembly. Refer to SE-23, “Removal and Installation – Seat Cushion Assembly”. Remove the seat belt from the seat belt guide. Remove the bolt at bottom of rear seat bolster. Lift the rear seat bolster to remove. INSTALLATION
When to use automatic locking retractor in Nissan Sentra?
WARNINGThe three-point seat belt with Automatic Locking Retractor (ALR) must be used when installing a child restraint. Failure to use the ALR mode will result in the child restraint not being properly secured. The restraint could tip over or be loose and cause injury to …
What do you need to know about the Nissan Sentra?
Seatback striker Seatback latch release knob Seatback latch assembly Seatback silencer (RH) Rear seatback frame (RH) Seatback latch release knob finisher Rear seat bolster trim (RH) Rear seat bolster pad (RH) Rear seat bolster (RH) Seatback trim (RH) Seatback pad (RH) Seatback hinge bracket (RH) LATCH bracket (RH) Seat cushion assembly
Tighten the rear seatback assembly bolts to specification. Refer to SE-22, “Exploded View”. Place the rear seatback assembly (LH) in the folded down position. Release the J-hook retainer (A) and unzip the seatback trim zippers (B). Remove two nuts (A) and the armrest assembly. Installation is in the reverse order of removal.
Removal and Installation – Rear Seat Bolster REMOVAL Remove the seat cushion assembly. Refer to SE-23, “Removal and Installation – Seat Cushion Assembly”. Remove the seat belt from the seat belt guide. Remove the bolt at bottom of rear seat bolster. Lift the rear seat bolster to remove. INSTALLATION
WARNINGThe three-point seat belt with Automatic Locking Retractor (ALR) must be used when installing a child restraint. Failure to use the ALR mode will result in the child restraint not being properly secured. The restraint could tip over or be loose and cause injury to
Seatback striker Seatback latch release knob Seatback latch assembly Seatback silencer (RH) Rear seatback frame (RH) Seatback latch release knob finisher Rear seat bolster trim (RH) Rear seat bolster pad (RH) Rear seat bolster (RH) Seatback trim (RH) Seatback pad (RH) Seatback hinge bracket (RH) LATCH bracket (RH) Seat cushion assembly