Where is the oil drain plug on a Nissan Rogue?
Move the Oil drain pan below the filter. It’s located on the passenger side of engine, right behind a plastic splash guard in the wheel well. Remove the oil filter.
How much oil does a 2010 Nissan Rogue take?
4.9 quarts
Capacity: 4.9 quarts (with filter)After refill check oil level.
What kind of oil does a 2010 Nissan Rogue use?
5W-30
Engine Oil
| Viscosity: | 5W-30 (All TEMPS) |
|---|---|
| Capacity: | 4.9 quarts (with filter)After refill check oil level. |
| Torque: | 25 ft/lbs (Oil Drain Plug) Install a new washer on the drain bolt. |
What type of oil goes in a 2010 Nissan Rogue?
Castrol Edge Synthetic Motor Oil 5W-30 1 Quart.
How to change the oil on a Nissan Rogue?
Locate the lever 2 in between the hood and grille and push the lever sideways with your fingertips. Raise the hood 3 . Remove the support rod 4 and in COMMON ITEM COMMON ITEM : CONSULT Function (BCM – COMMON ITEM) APPLICATION ITEM CONSULT performs the following functions via CAN communication with BCM.
What should I put in my Nissan Rogue?
Nissan Rogue Owners Manual: Recommended fluids/lubricants and capacities 1 Genuine NISSAN engine oil or equivelant 2 Engine oil with API Certification Mark 3 Viscosity SAE 0W-20 4 For additional information, refer to “Engine oil and oil filter recommendations” in this section.
Can you use CVT fluid on a Nissan Rogue?
Refill to the proper level according to the instructions in the “Do-it-yourself” section. Use only Genuine NISSAN CVT Fluid NS-3. Using transmission fluid other than Genuine NISSAN CVT Fluid NS-3 will damage the CVT, which is not covered by the NISSAN new vehicle limited warranty.
What kind of brake fluid does a Nissan Rogue use?
Genuine NISSAN Super Heavy Duty Brake Fluid (Available in mainland USA through your authorized NISSAN dealer) or equivalent DOT 3 See your NISSAN dealer for service. For additional information, refer to “Air conditioner system refrigerant and oil recommendations.” See your NISSAN dealer for service.