What to do if Def gauge reading is wrong?
1. Check to see if there is DEF in the tank. If the tank is not empty, drain the tank. On vehicles with A04-27943-000 and A04-27943-001 tanks, disconnect the DEF line from the DEF outlet port at bottom of the tank, and let the DEF drain into the drain pan.
What should the resistance be on a Def sensor?
IMPORTANT: When using an ohmmeter to measure the different resistance settings of the DEF level sensor, it is important that the readings fall below the range chosen on the ohmmeter. The resistance settings on the DEF sensor can range from approximately 68 ohms to 20,000 ohms.
What do the fault codes on Sea Doo mean?
Sea-Doo Fault Message List MESSAGE DISPLAY DESCRIPTION HIGH EXHAUST TEMPERATURE High exhaust temperature detected CHECK ENGINE Engine system malfunction or maintenance HIGH BATTERY VOLTAGE High battery voltage detected LOWBATTERY VOLTAGE Low battery voltage detected
How do you remove Def level from tank?
On vehicles with any other DEF header, use a siphon or invert the DEF tank after removal from the mount- ing brackets to empty the DEF from the tank. 2. Remove the tank from the vehicle. For instructions refer toGroup 49of the vehicle’s Workshop Manual. 3. Remove the DEF-level sending unit.
What does error code ER mean on LG refrigerator?
LG Error Code Er rt = Error is Room Temperature Sensor = Repair or Check Short in Sensor or Wiring Issue = Part or parts that need to be checked or replaced are… Room Temperature Sensor LG Error Code Er It = Error is System Error Inside Ice Maker = Repair or Check Self-Test Ice Maker = Part or parts that need to be checked or replaced are…
What does the error code F ds mean?
Freezer Fan Motor LG Error Code F dS = Error is Freezer Defrost Sensor = Repair or Check Sensor Short or Wiring Issue = Part or parts that need to be checked or replaced are… Controller Assembly (component that has the defrost thermistor and the fuse for the defrost system)
What does the error code ER FF mean?
LG Error Code Er FF = Error is Evaporator Fan Failed = Repair or Check Fan Motor, Control Board, and Wiring Harness = Part or parts that need to be checked or replaced are… Evaporator Fan Motor, Power Control Board, or Wiring Harness
What happens if the error code is not a current code?
Also if the code set is a historic code (not a constant light) after 50 start and run cycles of at least 30 seconds each in duration, the light will extinguish itself as long as the error hasn’t occurred again. If it were a current code, the light would remain lit while running. Above codes can also be set if 02 sensor fails.