What to do if you cant see the display on your car radio?
Through the main menu go to settings, ‘ILLUMINATION’ and ‘DIM SETTING’. Choose the ‘MANUAL’ setting and push to select. Press the back button until you exit the menu. You can now try holding the back button until the dimmer is switched on or off, then repeat the above process to adjust the brightness.
Why does my car radio keep asking for a code?
Whenever power is disconnected from the radio, it will ask for a radio code. In this episode of Proctor Car Tips, Rocky at Proctor Honda gives a quick car tip about your Car Radio. He speaks on why the Radio code comes on in your car, what to do when it does, and how to find the codes.
What to do if your car radio is too dim?
The dimmer can be set manually, synchronised to the clock or set to activate with your car lights. The final option requires that the illumination lead on the rear of the radio is connected to the relevant wire in the car. If the display is still too dim with the brightness set to the highest level the dimmer could be activated.
Why is my car radio not working at night?
The available setting ranges differ depending on the dim setting. The dimmer is used to dim the display and buttons at night, when the display does not need to be as bright as during the day. The dimmer can be set manually, synchronised to the clock or set to activate with your car lights.
What to do when your Honda radio says Erre?
To get rid of the ErrE message, you need to have the radio powered on continuously for at least one hour. After an hour, then CODE will come back. You can then enter your 5-digit code. If you don’t want to wait an hour, disconnect the battery–that will work too.
What to do if your car radio is locked?
Start your vehicle like normal, or turn the key until it’s in the “On” or “Accessory” position. Then, press the power button on the radio’s volume dial to turn on the radio. The digital display will read “LOC” if the radio is locked.
How do you change the hour on a Kenwood car radio?
Push the down arrow on the control knob located on the right end of the Kenwood car radio. Push it repeatedly until the center display shows “CLK ADJ.” Wait about one second. The clock display will start to flash. Push the up arrow on the control pad to increase the hour setting.
What happens if you leave the radio on for an hour?
If you leave the radio on for an hour it will reset itself to “code” or “enter code.” You can then enter the radio code. No need to disconnect the battery. I did this on my lunch hour. Also, if you pressed any keys before entering the radio code then they stayed in the radio’s memory.