How do I get my Nissan Titan out of anti theft mode?

How do I get my Nissan Titan out of anti theft mode?

Registered

1. Leave the ignition switch in the ON position. for approximately 5 seconds.
2. Turn the ignition switch to the OFF or LOCK. position, and wait approximately 10 seconds.
3. Repeat steps 1 and 2.
4. Restart the engine while holding the device.

What should I do if I have a Nissan p1610 code?

If the problem persists you have to have the dealer erase the code and reprogram the keys again. 1. Turn ignition switch OFF. 2. Turn ignition switch ON with registered key. (Do not start engine.) Wait 5 seconds. 3. Return the key to OFF position. 4. Repeat steps 2 and 3 twice (total of three cycles). 5. Start the engine. What does this mean?

What to do if DTC p1610 is high?

Scrutinizing the Fail Records vehicle mileage at the time the diagnostic test last failed may help understand the frequency in the condition that caused the DTC to set if DTC P1610 cannot be duplicated. This may assist in diagnosing the condition. Carry out an EOBD System Check. Task Over? Disconnect the main relay.

What does Nats code p1610 stand for?

I later pulled codes P1610 and 1614. Both P1610 and P1614 indicate a NATS (anti-theft system) malfunction, yet P1610 is a resulting DTC from the “LOCK MODE” condition which is set for various NATS malfunctions or an improper key being used. It prevents the car from starting (for some period of time, even if the key issue is rectified).

How much does it cost to diagnose a p1610 code?

The cost of diagnosing the P1610 code is 1.0 hour of labor. The auto repair’s diagnosis time and labor rates vary by location, vehicle’s make and model, and even your engine type.

If the problem persists you have to have the dealer erase the code and reprogram the keys again. 1. Turn ignition switch OFF. 2. Turn ignition switch ON with registered key. (Do not start engine.) Wait 5 seconds. 3. Return the key to OFF position. 4. Repeat steps 2 and 3 twice (total of three cycles). 5. Start the engine. What does this mean?

I later pulled codes P1610 and 1614. Both P1610 and P1614 indicate a NATS (anti-theft system) malfunction, yet P1610 is a resulting DTC from the “LOCK MODE” condition which is set for various NATS malfunctions or an improper key being used. It prevents the car from starting (for some period of time, even if the key issue is rectified).