How do you change clutch on Silverwing 600?
The only thing needed for clutch maintenance is to sand the shoes with some sand paper or emery cloth to take the glaze off . Lock in the parking brake remove the nut and remove the clutch .
What do you need to replace clutch bell on Honda Silverwing?
That special tool, or Honda’s own special tool, is only needed to remove the clutch bell, or clutch inner, as it’s called in the service manual. Regarding installation of an HIT clutch, if the HIT uses the stock Honda clutch inner, then no special tools will be needed.
What to look for in a clutch bearing?
Always make sure that all other components are in good condition. Check the clutch linkage for binding or mis-adjustments. Check clutch pedal free play and pedal reserve for proper setting. Check the clutch fork and input shafts for proper alignment.
Can a push pin be used as a clutch?
You may want to get a hooked, T-handled, spring puller so that you can remove the clutch and push-pin springs easier to sort out the initial and lock-up engagement to your liking. If the instructions which came with your HIT kit aren’t clear on the matter, all the springs are interchangeable between the clutch and the push-pins.
How to change the seal on a clutch?
1- Remove the clutch release mechanism. 2- Pull the clutch push rod out of the motor. 3- Squirt a little high quality grease through the push rod hole in the seal. 4- Reassemble everything.
How to replace clutch bearing on NSK Grill?
Put the pulley in the oven at 350 for 10 minutes, put the bearing in the freezer for at least an hour. The bearing will literally fall completely in place in the pulley because of the temp difference. Reassemble it all, add some oil, pull a vacuum for an hour, add freon. Done. I replaced my drier as well right behind the grill.
How big is a clutch bearing for an AC compressor?
Bearing Dimensions: 35x55x20 This Bearing will fit your Original (OEM) compressor. It will NOT fit after-market units. These items are shipped from and sold by different sellers. Show details In Stock. Ships from and sold by Coldzone777. In Stock. FREE Shipping on orders over $25.00. Details In Stock.
When did my clutch push rod seal start leaking?
During the latter part of the 2009 riding season, the clutch push rod seal of my motorcycle began leaking. I was not ready to tackle replacing the seal, so a little online research gave me a “quick fix” to hold me until I was ready to tackle this job.