What to do when your bike stalls in first gear?
I just got into the habbit of pulling it out by hand in the morning. At the end of the day either park it on the centre stand or diconect the switch from the frame and leave it hanging until next morning and if your bike starts fine then you know what the problem is. This post is not being displayed .
Is it OK to push your bike 3 ft?
OP push your bike 3 ft with the engine off, in gear, clutch in and report back. If it’s hard initially and then fine, it’s as Ariel says. It was just my two pennies worth based on what my friends bike had when the switch was at fault there.
What to do when put in first gear?
10 min job there will be a sump bolt on the bottom of the gear box dont forget let the bike drain standing upright then lean it one way for 5 mins then the other for another for 5 makes sure all old oil out, dont forget to put the sump bolt back in before toping up done that before mess ewverywere.
When do I drop from first to neutral my bike stalls?
This post is not being displayed . When I initially start up the bike and drop from neutral to first, the engine stalls pretty much every time. It only happens once and then I can drop down to first with no problems during a ride.
When do you Put your bike in 1st gear?
Remove ads, support ADV. Bike stalls immediately when put into 1st gear – clutch sticking? Discussion in ‘ Thumpers ‘ started by peteandrewd, Jun 23, 2016 . Hey everyone. So I recently replaced my clutch plates and fibres and finally had a chance to ride the bike.
Why does my bike stall when put into 1st gear?
So I recently replaced my clutch plates and fibres and finally had a chance to ride the bike. Upon start up, I let the bike warm up, held clutch in and then put the bike into gear, and it immediately jumped and stalled. It keeps doing it and I can’t ride the bike. The clutch has been bled properly with 0 bubbles.
Can you push a bike around in gear?
Bike is a 2011 KTM 530 EXC. With the bike shut off can you push it around in gear with the clutch pulled in? I would pull the clutch and soak the fibers. With everything pulled out check the basket for grooves or damage. UK for now. I was having the same issue. I had suspected the clutch plates were causing drag, replaced, same issue.
Can you roll a bike in gear with the engine off?
Nope. Can’t roll it in gear with the engine off. It’s a wet clutch system. Always had to warm the bike up thoroughly to be able to push it when shut off. Basket was already checked for grooves and wear and is fine.