Which battery terminal do you take off first on a motorcycle?
negative cable
Once you find it, sliding out the battery will allow you access to the battery terminals. It’s important to disconnect the negative cable first when disconnecting the battery cables, advises Revzilla. After the circuit is broken, you may remove the positive cable.
How do you remove a battery from a Harley Davidson?
Lift the passenger seat upward slightly, then pull it away from the rider’s seat. Unscrew the nuts from the back of the rider’s seat, using a 1/2-inch socket. Lift the rider’s seat upward slightly and pull it away from the gas tank. Unscrew the battery clamp bolt, using a Torx driver.
How do you change the battery in a Harley Ultra Classic?
Changing them out on an Ultra Classic is straightforward and should take no longer than 20 to 30 minutes of your time. 1. Open the tour pack. Unscrew the seat fastener on the rear fender using a Phillips screwdriver. 2. Push the seat as far forward as possible while lifting the rear of the seat off the frame. 3.
What happens if you remove positive cable on Harley Davidson?
If you remove the positive cable first, you risk causing a dangerous spark if the battery comes in contact with your bike’s frame. Bob has been dealing with these batteries for years and removes the neg from the battery.
Where is the negative battery on a Harley Davidson?
Unfortunately, the negative cable is to the right side of the bike behind the oil tank. It’s a bit of a tight fit and, on some models, it may be necessary to pull the battery as far to the left as possible to access the negative terminal. If there’s not enough slack in the cables to reach it,…
When to remove the battery from a Harley Sportster?
In this quick demonstration of the Harley Sportster battery removal, you’ll learn how to remove your bike’s seat and side cover so you can check on the condition of your battery and its operating components. It is strongly recommended that you remove the negative cable of the battery first and replace it last when servicing your bike.
How do you remove a battery from a Harley Davidson Road King?
Step 1 Unscrew the bolt securing the passenger seat to the Road King’s rear fender, using a Phillips screwdriver. Lift the passenger seat upward slightly, then pull it away from the rider’s seat. Unscrew the nuts from the back of the rider’s seat, using a 1/2-inch socket. Lift the rider’s seat upward slightly and pull it away from the gas tank.
Where is the battery located on a Harley Davidson?
Since Harley moved the battery under the seat in the mid-1990s, you don’t have to remove a saddlebag to replace the battery on many bikes. Your battery is hidden under the seat, which may have a strap across it, attached behind the saddlebags.
If you remove the positive cable first, you risk causing a dangerous spark if the battery comes in contact with your bike’s frame. Bob has been dealing with these batteries for years and removes the neg from the battery.