How do you replace the bearing on a trailer hub?
Place the hub, with the wheel studs facing up on a hollow cinder block or on a couple of 2x4s. Then use a 1″ wood dowel rod or scrap lumber that will fit into the center of the hub. Place the dowel rod against the inner bearing and knock out the bearing with the mallet. Do this in a circular motion.
What kind of wheel hub puller do I Need?
Three-Jaw Puller Set, 4 Pc. Slide Hammer and Puller Set, 14 Pc. Slide Hammer and Puller Set, 14 Pc. Slide Hammer and Bearing Puller Set, 5 Pc. Slide Hammer and Bearing Puller Set, 5 Pc. Gear Puller Set, 15 Pc. Gear Puller Set, 15 Pc.
Can a hydraulic puller be used to remove a bearing?
Heavy-duty pullers are made with hydraulic-assist rams, allowing for ease of removal. If the bearing is removed using a high-speed, cut-off tool, and if it is used carelessly, the shaft and housing may be damaged.
When to replace bearings, races and seals on a trailer?
Examine the surface of the race as you did with the bearings . Look for nicks and discoloration. If you see something you are not sure about, try running your fingernail over the mark; if it catches, the race will have to be replaced. Typically, if you have to get new bearings it is a good idea to replace the races, too.
How to replace the wheel bearing and hub?
Press in, out and replace wheel bearing and hub with simple tools. – YouTube If playback doesn’t begin shortly, try restarting your device. Videos you watch may be added to the TV’s watch history and influence TV recommendations.
Why do you need GMB wheel hub assembly?
You want to put the best quality hubs in your customers’ cars in order to reduce comebacks. When looking for a high-quality wheel hub assembly to keep in stock, you want to get one that’s: The wheel hub assembly offered by GMB fits the bill.
What happens if wheel hubs are installed the wrong way?
A wheel hub assembly is one of those parts that need to be installed the right way the first time. An improperly installed wheel hub assembly causes quite a few problems, such as: Vibrations when braking. Premature bearing failure.
What can cause a wheel bearing to fail?
When you have a failed wheel hub, it’s possible that the bore of the knuckle is damaged, too. That can cause premature wheel bearing failure. When the old hub is removed, use the opportunity to inspect the knuckle for damage. Look for corrosion and make sure a bore gauge rotates in the bore without any trouble.