Can you put wheel spacers on the rear only?
By adding spacers to the rear only you will experience an increase in understeer. Typically when adding spacers the front and rear tracks are widened equally, or close to it. The majority of GT customers who purchase our spacers go with 22 (F) / 25 (R).
Do wheel spacers go on front and back?
Is it typical to install wheel spacers on all four wheels? Yes, if you wish to keep the same proportional track (distance between tyre tread centers on the axle) front to rear. However, there can be special applications where you will only use them on one axle.
Should I use axle spacers?
Axle spacers are often necessary when a vehicle suspension lift kit has been added. One method is to lower the front axle differential the same amount as the rest of the suspension was lifted. This will maintain factory geometry of the front axle and allow proper operation for the most part of the front axle.
Where are the Spacers on a Harley Davidson?
A: Kevin, you will use one smaller spacer on each side of the wheel. They will be positioned right up against your wheel bearings and recessed, partially, inside of the wheel bearing seals. The longer spacer will go on the left side (pulley side) butted against the shorter spacer on one side, and the swing arm on the other side. Wheel spacers?
Where are the axle spacers in a 1993 Softail?
Q: These Harley axle spacers are in a 18″ x 5 1/2″ rear wheel assembly for an 1993 Softail delivered in a bag of parts. If possible, can you email me the orientation of reassembly?
Where do you put the spacer on a pulley?
They will be positioned right up against your wheel bearings and recessed, partially, inside of the wheel bearing seals. The longer spacer will go on the left side (pulley side) butted against the shorter spacer on one side, and the swing arm on the other side. Wheel spacers? You should have 2 short and one long.
A: Kevin, you will use one smaller spacer on each side of the wheel. They will be positioned right up against your wheel bearings and recessed, partially, inside of the wheel bearing seals. The longer spacer will go on the left side (pulley side) butted against the shorter spacer on one side, and the swing arm on the other side. Wheel spacers?
Q: These Harley axle spacers are in a 18″ x 5 1/2″ rear wheel assembly for an 1993 Softail delivered in a bag of parts. If possible, can you email me the orientation of reassembly?
They will be positioned right up against your wheel bearings and recessed, partially, inside of the wheel bearing seals. The longer spacer will go on the left side (pulley side) butted against the shorter spacer on one side, and the swing arm on the other side. Wheel spacers? You should have 2 short and one long.
How do you align a wheel on a Harley Davidson?
Attach one end off the remaining fishing line to your hook. String your line around the back wheel, down the side, around the front tire and down the other side. Trim to length, tie to rubber band and clip the hook attached to the first end to the rubber band. See figures 3a, 3b. Ideally, the line should be as far up the wheels as possible.