Where is the throttle cable on a magnum twin?
Engine Throttle Control Lever (Shown in Low Idle Position) Throttle Cable (Under Cable Clamp) Constant Speed Control (When Remote Cable is Not Used) Optional Throttle Cable Bracket Location High Idle RPM Stop Bracket Screw High Idle RPM Stop Bracket Governor Spring Throttle Control Wire 6 Magnum Twin Horizontal 5.
How do you put throttle control on a car?
Grasp the control cable and place it under the cable clamp. Pull until the cable is taut, then tighten the clamp screw. NOTE: The engine control lever should be against the high idle RPM stop bracket. 6. Move the application throttle control to the slow position, then to fast.
Where is the choke and throttle cable located?
Insert the control cable bowden wire in the proper hole of the engine control lever, which is located on the side of the carburetor air intake elbow.
How to install a choke control on a carburetor?
Insert the cable bowden wire into the choke control (front or reverse pull). Then place choke cable under the cable clamp. 3. Position the choke control so it bottoms, then pull it back approximately 1/16″ (1.5 mm). Make sure that the carburetor choke is fully opened before tightening cable clamp. 4.
Where is the throttle cable in a car?
Position the application throttle control in the fast throttle position. Then move the throttle control back 3/16″ (4.75 mm). Insert the control cable bowden wire in the proper hole of the engine control lever, which is located on the side of the carburetor air intake elbow.
Grasp the control cable and place it under the cable clamp. Pull until the cable is taut, then tighten the clamp screw. NOTE: The engine control lever should be against the high idle RPM stop bracket. 6. Move the application throttle control to the slow position, then to fast.
Insert the cable bowden wire into the choke control (front or reverse pull). Then place choke cable under the cable clamp. 3. Position the choke control so it bottoms, then pull it back approximately 1/16″ (1.5 mm). Make sure that the carburetor choke is fully opened before tightening cable clamp. 4.
When to move throttle control to slow or fast?
Move the application throttle control to the slow position, then to fast. Check the engine control to assure it stops against the high idle RPM stop bracket. NOTE: When the application throttle control lever is in the slow position the engine governor spring must be free of tension or pushing pressure. A non- free spring can affect the RPM.
What’s the best way to replace throttle cable?
Hold twist grip in full SLOW position. Pull firmly on cable to remove backlash. Adjust cable anchor so throttle cam is against idle stop when throttle cable anchor aligns with mounting hole in throttle body. Then, rotate anchor four turns toward the end of the cable.
What’s the difference between push pull and single throttle cable?
Initially, a push/pull throttle cable is an upgrade to the standard single throttle cable linkage. The throttle grip both works on the carbs when twisting/throttling up and when releasing/decelerating. This is a step up to the single throttle cable type where a spring is responsible for throttling down. Please click HERE for more insight.