How to diagnose no spark Arctic Cat?
First check the connections from the stator to the cdi. Make sure all connections are free of moisture, tight and use a small amount of dielectric grease. Check the ground. You have a ground wire coming from your stator and your CDI/ECU box. Make sure the ground is clean, tight and that the ground wires are not broken/loose.
How do you test an ATV stator on the ground?
ATV stator – Ground Test Setting a multimeter to Ohms, touch the negative wire to the ground and alternate the positive wire between every lead of the stator’s connector. If you have any reading different from OL (Open Loop), you have a faulty stator.
How does a static stator test work on a motorcycle?
The static stator test involves measuring from coil to coil — or phase to phase — within the stator, and also measuring from each coil/phase to ground. The exact range the stator should be within will vary from model to model, and manufacturer to manufacturer. Step 1. Set the multimeter to ohms.
What kind of stator do you use on a UTV?
The stators found in motorcycles, ATVs and UTVs are generally 3-phase stators. These consist of three separate windings wrapped around a series of points that circle the unit, with the ends of the three windings leading to an electrical connector. A stator test is either static or dynamic.
How to test a stator Arctic Cat 650H1 DIY?
Get a Multimeter here http://amzn.to/2nL1RKwToday i’m going to show you how to Test the stator on a Arctic Cat 650H1 ATV. if your having issues with your AT… Get a Multimeter here http://amzn.to/2nL1RKwToday i’m going to show you how to Test the stator on a Arctic Cat 650H1 ATV.
Why is my Arctic Cat 300 not charging?
I just helped a friend replace the stator on his 2000 Arctic Cat 300. It wasn’t charging at all before. We got it back together but it won’t accelerate.
Why is my Arctic Cat not accelerating after a stator replacement?
Do the ohms test on the old stator,,you can do it with it off the machine,,then compare it to the specs on your new one to see if that was your issue or not in the first place…It very well could have a drain/short in the system draining down your battery. The way to check that is to unhook your negative cable.
What should the voltage be on Arctic Cat?
You can test voltage without revving it way up,,,you just won’t get the maximum reading. Your battery should have 12.5V-13V while it is sitting, then you should see an increase towards 14V just at idle,,which it is doing,,,to tell you if it is charging or not.