Why is the tach not working on my Suzuki GSX-R?
The bike is a 2002 1000 and has a power commander3 installed other than that no other modifications has been done with the wiring. Thanks!! I also want to add that when ignition key is turned on the backlight of the gauge cluster is lit up but no display on the lcd and no tach movement.
What kind of parts are in a Suzuki 750?
Forks, Triple Tree, Axle, Brake Master Cylinder, Brake Caliper 1994 SUZIKI RF600RR exhaust header pipe. Not rusted thru. scratches and dents ok 2005 SUZUKI 750 STARTER TEMP. SENSOR FOR RAIDIATOR AND HEAD
What kind of power commander does a Suzuki GSX-R have?
I am worrying about buying another unit and having it fried again. The bike is a 2002 1000 and has a power commander3 installed other than that no other modifications has been done with the wiring. Thanks!!
Why is my Speedo not working on my GSX-R?
There is a common problem with KI Harness Connectors behind the front right cowl ! Take the right hand fairing cover off. Under the right hand inlet duct are three connectors one is not water resistant and water runs down the harness and corrodes out the connectors.
How do you install a tachometer in a car?
Locate all wiring junctions and prepare the tachometer for installation by arranging the wiring to make it easier to run the wires to their connecting junctions inside the passenger compartment and in the engine bay. Run the tachometer wiring around or through the dash board down to the firewall behind the gas pedal.
What is the Red Wire on a tachometer?
The red wire is for the ignition switch. Connect this red wire so that when the car is started the tachometer will begin operating. T-splice wire adapters allow for new wires to be spliced together with existing ones using pressure connectors that you squeeze around the existing wire to make the connection.
The bike is a 2002 1000 and has a power commander3 installed other than that no other modifications has been done with the wiring. Thanks!! I also want to add that when ignition key is turned on the backlight of the gauge cluster is lit up but no display on the lcd and no tach movement.
There is a common problem with KI Harness Connectors behind the front right cowl ! Take the right hand fairing cover off. Under the right hand inlet duct are three connectors one is not water resistant and water runs down the harness and corrodes out the connectors.
Why are my Speedo and tach not working?
Under the right hand inlet duct are three connectors one is not water resistant and water runs down the harness and corrodes out the connectors. Did you find the recommended reading relevant to this discussion?
What to do if your 80z Tach is not working?
If it has the long orange needle and there is no redline markings below 4500 rpm… It the correct tach for your 80Z. (Lower redline means it’s a V6 tach. Shorter red needle means it’s pre-79) The proper replacement should look like this.
I am worrying about buying another unit and having it fried again. The bike is a 2002 1000 and has a power commander3 installed other than that no other modifications has been done with the wiring. Thanks!!
What to do if your speedometer is not working?
If the speedometer on your automatic transmission Ford vehicle is not working, check the tail end of the transmission to see if the vehicle speed sensor (VSS) is securely attached. Another symptom of a bad speed sensor is sluggish automatic transmission shifting.
What happens if your speed sensor is bad?
Another symptom of a bad speed sensor is sluggish automatic transmission shifting. The vehicle’s computer also uses the speed sensor signal to control emissions and cruise control. Replacing the VSS in this 1992 Ford Ranger made quite a difference in its get up an go. Loading…