How do you install a turn signal on a Harley Davidson?
Point turn signal straight ahead then tighten ball stud clamp securely to hold lamp in place. Route wiring from kit to connector locations and cut wires to length. Following applicable instructions from Service Manual, install terminals to wires and install to connectors.
What to do if left turn signal is not working?
If you don’t have a manual, then have a look at the TS module and hopefully the pins are labled. If you apply 12 vdc to the (Lt out) pin -the Left turn signal lights should come on. (you’ve just bypassed the TSM) Next.. connect a jumper from (Lt in)pin to (Lt out) pin & press the Left turn signal switch.
Can a Dyna turn signal module go out?
I have a ’91 Dyna, and yes, I had the module go out on me. On inspection, it looked partially melted or burned. But before you go spend about a hundred dollars (HD, get it!!), make sure that both bulbs on that side are OK. When one bulb goes, the indicator and the other bulb should stay on steady when you try that side turn signal.
How can I tell if my turn signal module is faulty?
You can pretty much determine if the module is faulty by following the troubleshooting steps outlined in the manual. If you don’t have a manual, then have a look at the TS module and hopefully the pins are labled.
How to check turn signal module before buying a Harley?
NO blinkers, checked turn signal module for 12 dc at pins 1 to 2, have 12volts. How do I check module before buying one, cost $149.00 Clicking this will make more experts see the question and we will remind you when it gets answered.
Why does my turn signal on my Harley 883 not flash?
SOURCE: 2001 harley 883 right turn signal wont flash. Not check your front and rear signal ‘sockets” where the bulb goes in, check for rust or a bad connection shorting it out. If that’s not the problem, chech the wires under the rear fender to see if you have a bare wire from rubbing on the tire when hitting potholes etc.
What to do if your turn signal goes out?
check your front and rear signal ‘sockets” where the bulb goes in, check for rust or a bad connection shorting it out. If that’s not the problem, chech the wires under the rear fender to see if you have a bare wire from rubbing on the tire when hitting potholes etc. I had the same problem on my 92 softail. hope this helps.
Where does the turn signal module come from?
The turn signal module (TSM) is an electronic microprocessor that controls the turn signals and four-way hazard flasher. The turn signal module receives its information from the speedometer and turn signal switches. (TSSM), it is incorporated into the TSM module.