What to do if your cruise control stops working?
That bike still uses throttle cables and has a seperate cable from the cruise module/servo to the throttle body. Make sure it is still hooked up and in tact. Then check your cruise fuse. Then go the diagnostics as listed above. Turn your ignition on and see if your brake light is on without applying the brakes.
Is there a bad fuse on cruise control?
Bad cruise control fuse. 2007 ultra cruise problems! Riding along cruise kicks off set cruise again it runs for 15/22 kicks off again it did that a few times now it does nothing no greenlight at all fuses good ! Hi Mike. Check your front brake switch actuation/function.
Where are the dropout codes for cruise control?
The module stores the last 8 dropout codes starting with the most recent dropout. if you want to verify the flashes you just saw, then push the switch to RESUME and it will repeat the three digit code that you just read….. That bike still uses throttle cables and has a seperate cable from the cruise module/servo to the throttle body.
What causes cruise control to disengage on Harley Davidson?
Check your front brake switch actuation/function. If your front brake switch is damaged or misaligned, or aftermarket levers are installed; your cruise will disengage if the module/ecm detects brake function.
That bike still uses throttle cables and has a seperate cable from the cruise module/servo to the throttle body. Make sure it is still hooked up and in tact. Then check your cruise fuse. Then go the diagnostics as listed above. Turn your ignition on and see if your brake light is on without applying the brakes.
Bad cruise control fuse. 2007 ultra cruise problems! Riding along cruise kicks off set cruise again it runs for 15/22 kicks off again it did that a few times now it does nothing no greenlight at all fuses good ! Hi Mike. Check your front brake switch actuation/function.
How does cruise control work on a Harley Davidson?
The Harley cruise control function is governed by the motorcycle’s ECM. The ECM monitors the vehicle speed sensor (VSS) to establish the bike’s current speed. The ECM then modulates the throttle control actuator to maintain a constant vehicle speed.
The module stores the last 8 dropout codes starting with the most recent dropout. if you want to verify the flashes you just saw, then push the switch to RESUME and it will repeat the three digit code that you just read….. That bike still uses throttle cables and has a seperate cable from the cruise module/servo to the throttle body.
Can a check engine light cause a cruise to not work?
If your Check Engine light is on, the cruise may not work, especially if the VSS is malfunctioning. Older vehicles may use speed information from the speedometer.
Why does my cruise control drop out of engagement?
Does your cruise control fall out of engagement partway up steep hills? Actually, it will normally drop out if the engine has to work too hard, mainly because after a while there isn’t enough vacuum left to pull in the servo after sustained near-wide-open-throttle. You’ll just have to put your foot into it.
What causes a vacuum line to fall off a cruise control?
If it has fallen off, there’s no vacuum to the actuator and no force can be applied to the throttle. We’ll get ahead of ourselves here and mention that a vacuum line that looks fine may have a subtle leak caused by aging, brittle rubber or connections that don’t seal well.