How do you shift a Harley Davidson Fat Boy?
Ease the clutch out and adjust the throttle as needed to avoid slowing the rear tire enough to break traction. Downshift from sixth to fifth at 50 mph, and the successive gears at 40, 30, 20 and 10 mph.
What kind of transmission does a Harley Davidson Fat Boy have?
The 2014 Harley-Davidson Fat Boy comes equipped with a six-speed transmission. The driver footboards allow for the use of a heel-toe shifter, which allows for much greater comfort over rides that require frequent shifting, such as in city traffic or while negotiating steep grades and turns.
When to replace a shift shaft on a Harley Davidson?
If pinch bolts become loose, remove them, clean them, and reinstall to factory torque specs with Loctite. If shift arm splines or shaft splines are worn; the components should be replaced. If a shifter shaft is to be replaced, it is also important to replace shifter shaft bushings at that time. Proper shift leverage is very important.
What happens if your shift linkage is wrong on a Harley Davidson?
If your shift arms are not properly aligned or your Harley-Davidson gear shift linkage is set to an incorrect length; you may experience binding, which will limit, or diminish your leverage. If you are replacing, or reinstalling the stock shift linkage on your Harley; it is important to assemble it back to the exact position it was in previously.
Is there a problem with the shift linkage?
Binding issues with the shift linkage is one of the most common transmission problems, as well as one of the easiest to remedy. Figure 2. Adjusting the linkage arm is as easy as loosening the top gear, pulling it off and making a small, even one spline, adjustment.
When to replace the stock shift linkage on a Harley Davidson?
If you are replacing, or reinstalling the stock shift linkage on your Harley; it is important to assemble it back to the exact position it was in previously. When installing an after-market shift assembly, it is important to try copying the original, stock, configuration whenever possible to achieve the same, correct leverage.
Is there a shifter pawl adjustment for a twin cam?
There is not a shifter pawl adjustment for your Twin Cam. Disconnect your shift linkage from the transmission shift arm. If you still can not correctly shift through the gears, your issue is within the transmission.
When to replace the shifter linkage on a Harley?
Replace that bolt if that happens. The stock Harley shifter linkage will fail on you at some point. I strongly suggest you replace your shifter linkage as soon as you by a Harley with a quality aftermarket shift linkage.
Ease the clutch out and adjust the throttle as needed to avoid slowing the rear tire enough to break traction. Downshift from sixth to fifth at 50 mph, and the successive gears at 40, 30, 20 and 10 mph.
When do you need to address gear shift linkage?
If you are experiencing Harley neutral issues, “hard neutral”, or having a tough time shifting your Harley, you may need to address your Harley-Davidson gear shift linkage as an assembly. Sometimes, a misaligned shifter linkage splines will be obvious to diagnose. Other times you may need to examine the assembly more closely.
There is not a shifter pawl adjustment for your Twin Cam. Disconnect your shift linkage from the transmission shift arm. If you still can not correctly shift through the gears, your issue is within the transmission.