Why is my four wheeler clicking when I start it?
Your ATV most likely clicks when you try to start it because of the battery. The reasons for this are numerous, from loose connections to a current draw that drains the battery. If the battery is not the cause, the ATV probably has a faulty starter solenoid.
Is clicking a bad starter?
Unlike an electrical problem, an issue with the starter or starter relay (a switch-like device that transmits power to the starter) will trigger a single loud clicking sound rather than rapid clicking sounds. One of the symptoms of a bad starter is a single clicking noise when you turn the key or push the start button.
Why does my 2004 Honda rancher not start?
Gotta be the ground. My ’04 350 Rancher won’t start with the button all the time. If I pull the starter cord through, eventually the starter will run and the engine starts. I keep the battery on a battery tender and even off the tender for a couple days, I’m still reading over 12 volts, usually in the 13 range.
How to check starter voltage in Honda rancher?
First measure the battery voltage ( + lead to + terminal on battery / – lead to – terminal on battery) with the igntion off. Then perform the same steps while pressing the start button and attempting to turn the starter over for 15 seconds. These voltage specs will be in DC or DCV depending on the meter.
Where is the start button on a Honda rancher?
When the start button is pressed .. All I get is clicking under the seat in the battery area.. The battery is fully charged and all connections are tight.. Sometimes it starts with the button though !!!!
How to change starter silinoide on Honda rancher?
Ill make this a little quicker here. Hook your red meter lead to the starter side of the solenoid and your black lead from the voltage meter to the negative terminal on the battery. The switch the igntion on and then press the starter button. Post the voltage here.