What do you need to know about the Dyna ignition system?
DESCRIPTION The DYNA 2000i Digital Ignition is designed to replace the factory ignition module and sensor used on 1983 and later Harley-Davidson EVO motors. It is also an ideal upgrade for early electronic and breaker-point systems that require a mechanical advancer.
Where is the 12V supply on a Dyna 2000i?
Locate the original white wire on the bike that is the +12v supply from the ignition switch to the coil (discussed above). Connect this original white wire and the white wire from the DYNA 2000I to one of the coil primary terminals. Locate the pink wire from the DYNA 2000I . Connect this wire to the unconnected primary terminal on the coil. 4.
How to program a Dyna 2000i Mfg engine?
2. Feed the wires of the DYNA 2000I through the hole in the engine case. Place the DYNA 2000I in the engine with the timing pickup (near the switches) at the mark made in step 1. Install the two screws that held the stock cam position sensor, finger tight. 3. Coil connection.
Where is the timing switch on a Dyna 2000i?
Feed the wires of the DYNA 2000I through the hole in the engine case. Place the DYNA 2000I in the engine with the timing pickup (near the switches) at the mark made in step 1. Install the two screws that held the stock cam position sensor, finger tight. 3. Coil connection.
How to turn on the ignition on a Dyna s?
1. Connect a 12 volt test light from the black coil wire to ground (engine case). 2. Rotate the engine until the front cylinder is on the compression stroke. 3. Remove the crank case timing hole plug. 4. Turn ignition on. 5.
When did they change the front rake on the Dyna?
1995: Until this year, all Dynas had a 32-degree front rake, but in 1995 a more responsive 28-degree rake was introduced to the sportier Dyna models. 1999: Evolution engine is replace with the new 88ci Twin Cam engine in the Dyna frame.
How to install advance Assembly on Dyna’s engine?
Push the rotor down until it engages the weights on the advance assembly [it will only go on one way}. Ensure that the rotor rotates freefy·on the shaft as the advance weights move out and back. · 6. Install the advance/rotor assembly on the engine making sure the pin on the advance assembly is engaged in the slot on the engine.
Which is bigger the Dyna or the tourer?
In families, there are bigger brothers and little brothers, but the one in the middle is the kid that generally gets less attention than the other two. This is a characteristic that the middle child shared with the Dyna, which didn’t get as much attention as the smaller Sportster or as the larger Tourers.