What kind of cable is a jump wire?
RF jumper cables – Jumper cables is a smaller and more bendable corrugated cable which is used to connect antennas and other components to network cabling. Jumpers are also used in base stations to connect antennas to radio units.
How to install a jumper wire to bypass the lid switch?
Insert a jumper wire into the lid-switch connector that attaches to the control panel. The connector has two wires attached to it, one violet and one gray. Bridge these two wires by inserting the bare ends of a jumper wire into the connector.
Where are the jumper wires on a USB?
Jumper wires with crocodile clips. Jump wires at the end of a multi-colored ribbon cable are used to connect the pin header at the left side of a blue USB2Serial board to a white breadboard below. Another jumper cable ending in a USB micro male connector mates to the right side of the USB2Serial board.
How do you make an electrical outlet with a jumper?
First, strip 5/8 inch to 3/4 inch of insulation from the end of each wire in the receptacle box, and from both ends of each jumper. Next, hold the wires for each splice parallel (including the jumper) with the ends evenly lined up. Clamp your pliers over the ends and twist the wires together clockwise with four to five turns.
Insert a jumper wire into the lid-switch connector that attaches to the control panel. The connector has two wires attached to it, one violet and one gray. Bridge these two wires by inserting the bare ends of a jumper wire into the connector.
First, strip 5/8 inch to 3/4 inch of insulation from the end of each wire in the receptacle box, and from both ends of each jumper. Next, hold the wires for each splice parallel (including the jumper) with the ends evenly lined up. Clamp your pliers over the ends and twist the wires together clockwise with four to five turns.
What to do if the splice does not cover the wires?
If the connector does not completely cover the bare wires, use a larger connector or remove the connector and cut off enough wire from the splice so that the connector completely covers the bare wires. At this point, you should have three completed splices in the receptacle box and the only loose wires should be the jumpers.
How do you bridge a jumper wire on a mower?
Squeeze the locking tab on the harness and pull it out of the connector. Insert a jumper wire into the lid-switch connector that attaches to the control panel. The connector has two wires attached to it, one violet and one gray. Bridge these two wires by inserting the bare ends of a jumper wire into the connector.