What PSI should my mountain bike tires be?
Imagine you’ve purchased a new set of mountain bike tires that recommend a range of at least 35 and no more than 60 psi. Begin by inflating your tires to the middle of the range, adjusting the inflation depending on your weight. If you’re a heavier rider, you may want to start off at around 50 psi for each tire.
What PSI is Fox DPX2?
350 psi
Do not exceed maximum air pressure: FLOAT DPX2 air shocks have a maximum air pressure of 350 psi. 4.
What should the SAG be on a rear shock?
For an example, your target sag percentage is 25% and your rear shock available travel is two inches (~50 mm); your target sag setting will be ½ inch (~12.5 mm), 25% of available travel (12.5 ÷ 50 = 0.25).
How to achieve correct air pressure with SAG?
Make sure that you are on a level surface and have an assistant hold your handlebars, or position your bike next to a wall or table to support yourself while getting into a riding position. Mount your bicycle and bounce lightly while holding onto a single brake only, to compress both front and rear suspension slightly.
How to set up your shock and fork suspension on the bike?
Ideally for an XC set-up, you want to start with 25% sag. Push the rubber O-Rings down the base of the shock and fork. Have your friend hold up your bike facing you and holding the handlebars with the front tire between their knees.
How do you adjust the rear shock system?
To access the rear shock system Schrader valve, open the left side saddlebag. Similarly, the whole saddlebag can be removed if you are using a larger air pump. Check the air pressure in the shock system. If air adjustment is needed, first add 3-5 psi to the system before adding or removing any air.
How is the air pressure in a Harley Davidson shocks determined?
Generally, the proper amount of air pressure in the shocks is determined by the combined weight of the rider, passenger, and cargo (if applicable). Using the charts below, select the appropriate air pressure for the given weight range as a starting point. Figure 1. FLH Touring model air pressure recommendations. Figure 2.
How to check air pressure on FLHX shocks?
FLHX and FLHRS air pressure recommendations. Click on image to enlarge. Air shocks can gradually lose air over time, so it is best to check your air pressures periodically and before any long ride. To access the rear shock system Schrader valve, open the left side saddlebag.
When to add air to a shock system?
Check the air pressure in the shock system. If air adjustment is needed, first add 3-5 psi to the system before adding or removing any air. This will prevent the system from losing any fluids if it is completely out of air.