Do you check Harley transmission fluid on kickstand?
The transmission oil is checked with the motorcycle on a level surface and on the kickstand. The transmission oil level is correct when between the Add and Full marks on the dipstick.
How to check the transmission fluid in a Harley?
Turn the engine off and let it stand for 20 to 30 seconds and repeat the rest of Step 3 to read the new levels. Repeat this until the proper amount of fluid has been achieved. When your transmission level is reading correctly, screw the dipstick firmly back in place before starting the engine.
How can I check the fluid level in my automatic transmission?
The fluid level in a manual transmission must be checked with the vehicle on a hoist to enable the technician to reach a plug in the bottom of the transmission. To check your automatic transmission fluid, follow these steps: Pull out the dipstick. With the gearshift in Neutral or Park and the parking brake on, let your engine run.
Where to find fluid dipstick in manual transmission?
Where to find the transmission fluid dipstick if you have front-wheel drive. The fluid level in a manual transmission must be checked with the vehicle on a hoist to enable the technician to reach a plug in the bottom of the transmission.
What to do if your transmission fluid is not clear?
Wipe the dipstick with a clean, lint-free rag; then reinsert it and pull it out again. If the transmission fluid is clear but doesn’t reach the “Full” line on the dipstick, use a funnel to pour just enough transmission fluid down the dipstick tube to reach the line. Don’t overfill! There are several types of transmission fluid.
How do you change transmission fluid on a Harley Davidson?
Wipe off the area around the drain opening and then screw the drain plug back in. Torque the plug to 14 to 21 ft/lb. Now clean any oil that spilled over the frame, exhaust etc. Moving to the top, refill the transmission with 20 to 24 ounces of lubricant.
How do I check transmission fluid levels in a Sportster 883?
The Sportster 883 is a motorcycle made by Harley Davidson. The transmission fluid is part of the bike’s oil system. You need to checking the fluid level periodically to ensure the engine runs smoothly. The job takes a good deal of time because it isn’t readily accessible. You must open up the primary housing on the motor to get to it.
What’s the best way to check your transmission fluid?
Insert long funnel into automatic transmission fluid dipstick hole. Carefully add automatic transmission fluid in small increments and recheck level each time until fluid level reaches “warm” line. CAUTION: DO NOT OVERFILL OR SPILL AUTOMATIC TRANSMISSION FLUID ON HOT ENGINE PARTS! Reinsert automatic transmission fluid dipstick fully. You’re done!
How do you check the oil level on a Harley Davidson?
Now, remove the dipstick/fill plug and view the oil level. The transmission oil level is correct when between the Add and Full marks on the dipstick. Checking oil on Harley is similar however there is the option to check the oil level on the kickstand or with the vehicle upright. Again, start with the motorcycle already warm.