Does revving the bike engine in neutral damage it?
Is it bad to rev your motorcycle engine? For the most part, it is not bad for a motorcycle engine to be revved whether it be in neutral or in gear. However, a single high rev should not last more than a few seconds because that can cause damage to the cylinder walls and pistons as they overheat.
Why do dirt bikers rev their engines?
When stopped at a stop light the engine idles, which is a constant engine speed. Since a motorcycle in the break-in period should avoid a constant engine speed, the Rider revs the engine. What it boils down to is that if you do not “break-in” your engine you will get bad mileage or even ruin it.
Why does my bike Rev when I release the throttle?
It sounds like the carb slide or cable is sticking IMO,as said above. Its so strange because when I release the throttle it just goes back into place, I also tryed usng the throttle cable on other bike. I also adjusted the throttle wire tension barrel thing and put it all the way down (least tightest).
What does blip throttle and Revs hang mean?
Blip throttle and revs hang = rich/lean? are adjusted towards the lean side. If on the other hand a quick blip returning to the idle rpm the bike is running a little rich. Does anyone know of the underlying mechanism to this analysis?
What should I do if my throttle is not working?
The first thing I would do is check for proper operation of the throttle cables. Make sure they are returning to the proper location and not holding the throttle open by being gunned up or in a bind somewhere along their routing. When was the last time you lubricated the cables?
Do you lean the throttle for drag racing?
Maybe that “somebody” was a racer who wanted to enhance off-idle throttle response for drag racing starts.) Lean the idle mixture and set the idle speed accordingly. through your gasoline often enough. Clean ’em out by adding about 2
It sounds like the carb slide or cable is sticking IMO,as said above. Its so strange because when I release the throttle it just goes back into place, I also tryed usng the throttle cable on other bike. I also adjusted the throttle wire tension barrel thing and put it all the way down (least tightest).
How do you adjust the throttle on a Rev2?
Start with the pull cable and adjust the adjuster until there is approxi- mately 1-2mm of free play in the cable. The throttle should be able to rotate a few degrees before startingto open the carbs or throttle bodies. Once this adjustment is complete, twist the throttle andlet go several times. The throttle should snap back closed very quickly.
What does it mean when your bike is in neutral?
Basically when the clutch is not able to engage the selected gear properly the drive shaft stays in the mode of stasis . i.e simulating the effect of the bike being in neutral. The only difference between a regular neutral and this one is that you don’t see the neutral light on the dash.
Is there a fix for a false neutral on a motorcycle?
Unfortunately there is no way to “Permanently Fix” a false neutral issue, it depends on the bike and the gearbox and all of the above reasons, However you can do the below things to reduce the occurrence of hitting a false neutral on your next trip. Add fresh synthetic oil to the bike.