How do you remove oil seal from lower fork?
Pull the rubber dust boot off of the top of the lower fork leg and slide it off of the upper fork tube. Pry out the oil seal circlip from the top of the fork leg with a flat screwdriver. Remove the fork tube from the lower fork leg, using a back-and-forth motion to pull the tube, fork seal and damping rod out of the fork leg.
How much does it cost to replace Fork seals on a motorcycle?
If you’re not careful, the oil could drip onto the caliper, rendering the brake useless. Set aside around two hours to replace the fork seals. Gather all the parts and tools you’ll need in advance. Even if you only need to replace one seal, replace them in pairs to keep them on equal footing. The parts are usually under $20.
How do you change the seal on a Goldwing Fork?
Reinstall the drain plugs with fresh drain plug gaskets and torque the plugs to factory specifications for your year of Goldwing. Remove the large snap-ring at the top of the lower leg with a pair of inside snap-ring pliers. Remove the Allen head bolt in the bottom of the lower leg to release the internal damper. Discard the copper gaskets.
What’s the best way to replace a fork?
Remove the brake calipers, fender, front wheel and any other hanging cables. Disassemble the fork. Loosen the bolts further and pull downward on the fork while twisting. Remove the fork cap carefully. Because it is spring loaded, be careful not to stand in the way of the cap as you remove it.
How do you replace oil seal on front fork?
Situate the clip and dust seal back onto the fork. Place the damping rod back inside. Pour new oil into the fork, measuring the height as necessary. Re-install the spring and screw on the fork cap. Tighten the bolts. Repeat the process on the other fork leg. Reassemble your motorcycle’s front end. How much oil goes in the front fork?
How do you replace a fork seal in RevZilla?
RevZilla photo. It’s easy to do. Cut off a chunk of 35mm film. Pop your dust boot up. Gently slide the film between the seal and the fork tube. Work it around the seal, up and down, until you get back to where you started.
How do you remove oil seal from Kawasaki Vulcan?
After the forks are off the bike you’ll have to drain the fluid, remove the dust seal and oil seal retaining clip. Then remove the bolt at the bottom of the fork that holds everything together and ‘slam’ the fork apart. Reassembly is a straightforward reverse of disassembly.
How much does it cost to replace a fork seal?
Gather all the parts and tools you’ll need in advance. Even if you only need to replace one seal, replace them in pairs to keep them on equal footing. The parts are usually under $20. Be sure to calculate how much oil you’ll need.