Can you loop a throttle cable?
Loops are OK. Tight S bends are not. Check the cable periodically by unhooking it at the carb and pulling the cable in out to check for roughness.
Can you shorten boat throttle cables?
There is no known method of changing the length of a remote throttle or shift mechanical cable in the field. Your best–and probably only option–is to purchase new cables of the proper length.
How do you change throttle cable from carburetor?
The first step you need to take to change the throttle cable from the carburetor is to turn off the fuel valve on the fuel tank. Then track the fuel line down to the carburetor and remove the hose. If the fuel line is cracked or has become old then you will need to replace it so that there will be no leaks.
What should I do if my throttle cable is not returning?
If the throttle does not completely return the cable may be binding, incorrectly routed, frayed, or corroded, which warrants further investigation. With the bike OFF, twist the trottle open to the stop and let go.
Where is the throttle cable on a quad?
The locknut is attached to the tubular L – shaped fitting which comes out of the triangular cover on the brake side of the quad. After unscrewing the locknut, unscrew the three head screws on the cover plate. Now look under the plate and there you will see that the throttle cable is attached to a brass or gold colored plug.
What should the tension be on the throttle cable?
The accelerator cable tension is usually set so that 2-3mm of free play is present in the throttle grip. Once the correct tension has been applied, the lock nuts should be snugged and any dust covers should be slid back over the adjusters.
How do you release throttle cable from Carb?
Release the end of the throttle cable from the carb so you can take it in your hand and hold it up in the air (so gravity will help you). Usually, the way you release it is by pulling the carb throttle wide open (twist your wrist at the top) and hold it open then maneuver the wire around and pop the cable out of the carb.
What’s the best way to clean a throttle cable?
In order to clean, first, spray off the dirt using compressed air and a light degreaser or brake cleaner. Then, use a lubricant designed for throttle cables. My two favorites are dri-slide and sprayable gel lube. If you don’t lubricate and clean your throttle cable it can stick open, causing the bike to be stuck full throttle.
What happens if you don’t lubricate your throttle cable?
If you don’t lubricate and clean your throttle cable it can stick open, causing the bike to be stuck full throttle. This happened to me recently on my Honda Elite Scooter, and it was a scary ride at full throttle for a couple seconds.
What can I do to prevent my throttle from getting stuck?
Regularly checking and lubing the throttle components will prevent the cable from early damage. It will ensure a smooth throttle action and prevent the chance of the throttle getting stuck wide open. In order to clean, first, spray off the dirt using compressed air and a light degreaser or brake cleaner.