How do I reset my Harley-Davidson alarm?
Disarming with Your PIN
- Turn the key to “Ignition.”
- Hold both turn signal switches until you receive confirmation.
- Enter the first number by pressing the left turn signal the same number of times as the digit.
- Press the right turn signal once. Repeat steps 3 and 4 until you have entered your PIN.
Why are the turn signals on my Harley Davidson not working?
I’m not getting any power to the right side turn signals, the green arrow on the dash don’t light up on right, and turn signals are very dim and slow on left side. Wiring seems to check out, fuses ok.
Why is my left turn signal not flashing?
When it’s not working, there is no signal front & rear and no signal indicator either. When working, both markers function properly as does the indicator. With new bulbs installed and sockets cleaned, I’ve narrowed the problem down to either the left turn signal switch or the turn signal module.
Why is my turn signal not flashing on my Fatboy?
Had the same problem on a 99 Fatboy changed the ignition switch and problem was solved Have a 97 FXDWG. Installed a badlander load equalizer 17 years ago for run and brake lights on the rear. If the bike is not moving the right turn signal functions correctly.
Why are the turn signals on my hog not flashing?
Find the orange wire that feeds 12 volts to your turn signal module. Power it off of a breaker that is powered on, both 1 & 2 “clicks”. My speedometer is working erratic. When I give it throttle the speedimeter digital reading goes blank and the engine light comes on and the turn signals will not flash. When I come to a stop they work
When it’s not working, there is no signal front & rear and no signal indicator either. When working, both markers function properly as does the indicator. With new bulbs installed and sockets cleaned, I’ve narrowed the problem down to either the left turn signal switch or the turn signal module.
How can I tell if my turn signal module is faulty?
You can pretty much determine if the module is faulty by following the troubleshooting steps outlined in the manual. If you don’t have a manual, then have a look at the TS module and hopefully the pins are labled.
Why is my turn signal on on my Dyna Glide?
Diagnosing and clearing the codes on each module is really simple, as explained below. Before resetting the Turn Signal Security Module, you should check some of the basic reasons as to why the red light is turned on. These reasons include a dying key fob battery, blown turn signal bulb, or bad fuse.
Had the same problem on a 99 Fatboy changed the ignition switch and problem was solved Have a 97 FXDWG. Installed a badlander load equalizer 17 years ago for run and brake lights on the rear. If the bike is not moving the right turn signal functions correctly.