Why is my Sportster not cranking or starting?
1. Cable to battery connections are oxidized and maybe the cable to starter and ground. Clean them both up and test again. 2. Negative cable is corroded under the rubber seal on the engine side. Peal it back and have a look. One thing to remember is that the starter circuit is marginal at best.
Why does my Harley Davidson bike not start?
If the engine doesn’t crank, it could be because of a failure at any of those stages, a weak battery, or a bad starter. If the motor cranks and still won’t start, then it is likely a fuel or spark issue. A few tests can be performed to quickly track down the problem.
What does it take to start a Harley Davidson Sportster?
This article applies to the Harley Davidson Sportster. What does it take to start a Sportster? When you turn the ignition switch to the on position, current is sent to the start button. Pressing the button sends power to the starter solenoid, which sends a large amount of current from the battery to the starter to turn the motor.
Is the 1200R Sportster still cranking at 8500 miles?
Yep, my 1200r doing that exactly since i got it. Acquired the bike with 1300 miles on it and now it’s at 8500 miles and on the 2nd battery, still does it. I’ve had this happen before when the battery was getting weak. I replaced the battery and the solenoid contacts had pitted.
Why is my Harley Davidson Sportster not starting?
Place your Sportster in second or third gear for the best results. A battery that can’t start your engine may no longer be recharging properly because of its age and current state of charge. The ground cables that connect the battery to your Sportster frame must also be undamaged and free of corrosion.
Why does my bike not start when I push the starter button?
Pressing the button sends power to the starter solenoid, which sends a large amount of current from the battery to the starter to turn the motor. If the engine doesn’t crank, it could be because of a failure at any of those stages, a weak battery, or a bad starter.
What to do when your motorbike wont start?
Look up direct start button cover. It can get you out of a jam when the solenoid acts up. Won’t help if the battery is to low to crank the engine though. Was this answer helpful? I dont own a motorbike.
What happens when the crank sensor on a Harley goes bad?
In newer models, the crank position sensor is designed in such a way that it allows you to reach your destination even after it goes bad. Usually, the symptoms of a bad crank position sensor on Harley Davidson are quite easy to notice. For example, you experience slight hesitation with the engine or reduced mileage, etc.
Why does my starter click when trying to start?
The starter will either push the jack shaft out and spin (then the starter is good )or the jackshaft will click in and out rapidly and then you’ll know it’s the solenoid hold in coil. But it’s probably just the battery. Was this answer helpful?
Why does my Harley Davidson make a hard clicking sound?
Clicks when trying to start does not engage. I have a Harley-Davidson 1999 sportster 1200. I get a hard fast clicking sound when trying to start. I Have put the battery on a charger and let it charge overnight. It still does the same thing. Is this a bad battery?
What should I do if my starter motor is out?
Like he said, most likely is your battery. However, when the hold in coil is out on the starter solenoid it will do the same thing that you are just describing. In that case you need a new starter motor or you could try to rebuild your solenoid. The starter motor and is very easy to swap out. First, disconnect your battery. Do not skip this step.
Why does my starter not work on my Harley Davidson?
If you press the start button and it just clicks and sounds like the starter drive gear does not align with the flywheel and does nothing, I cross the lugs at the starter relay and it throws the starter clutch drive gear into the flywheel and tries to start but will not stay engaged to turn the engine or just spins.
The starter will either push the jack shaft out and spin (then the starter is good )or the jackshaft will click in and out rapidly and then you’ll know it’s the solenoid hold in coil. But it’s probably just the battery. Was this answer helpful?
Clicks when trying to start does not engage. I have a Harley-Davidson 1999 sportster 1200. I get a hard fast clicking sound when trying to start. I Have put the battery on a charger and let it charge overnight. It still does the same thing. Is this a bad battery?
Why does my bike click when trying to start?
SOLVED: Clicks when trying to start does not engage. – Harley-Davidson Sportster Evolution – iFixit Clicks when trying to start does not engage. I have a Harley-Davidson 1999 sportster 1200. I get a hard fast clicking sound when trying to start. I Have put the battery on a charger and let it charge overnight. It still does the same thing.
Is the negative cable on the Sportster 1200 corroded?
Negative cable is corroded under the rubber seal on the engine side. Peal it back and have a look. One thing to remember is that the starter circuit is marginal at best. The 883 and the 1200 use the same battery and starter motor but the 1200 has an extra 125 or so pounds of compressions.
Pressing the button sends power to the starter solenoid, which sends a large amount of current from the battery to the starter to turn the motor. If the engine doesn’t crank, it could be because of a failure at any of those stages, a weak battery, or a bad starter.
Why is my Harley Davidson Sportster not charging?
If a new battery fixes your problem, confirm the charging system is working properly by performing the same test with the engine running. A normal reading is near 14 volts. If you find a different value, move to Step 6. Even if your battery’s charge level is normal, it may not have the capacity under load to supply enough amperage.
1. Cable to battery connections are oxidized and maybe the cable to starter and ground. Clean them both up and test again. 2. Negative cable is corroded under the rubber seal on the engine side. Peal it back and have a look. One thing to remember is that the starter circuit is marginal at best.
Why does my Harley Davidson crank but not start?
There have been a few reports of a P1009 code – incorrect password also. It appears the turn signal and stalls or cranks but will not start. Try removing the ecm and security fuses, wait ten minutes and reinstall the fuses. This “reboots” the turn signal module and the motorcycle will then start from that point on.
This article applies to the Harley Davidson Sportster. What does it take to start a Sportster? When you turn the ignition switch to the on position, current is sent to the start button. Pressing the button sends power to the starter solenoid, which sends a large amount of current from the battery to the starter to turn the motor.
How to check spark plugs on Harley Davidson Sportster?
Insert a spark tester into the wire and attach the tester to ground. Remove the fuel pump fuse. Refer to the article Fuse Box Information for fuse locations. Crank the engine and watch for spark. If spark is consistently present, the problem most likely lies with the spark plugs and you should continue to Step 2.
How to make a motorcycle crank but no start?
Grounding plugs to block wont give you a spark. youll have to make a set of dummy plugs by taping them together. turn spark plugs opposite of eachother, metal to metal and tape with electrical tape. Then plug the boots back on and check again. Click to expand… I don’t understand this at all.
How to check ignition resistance on Harley Davidson Sportster?
Set your meter to read ohms and place your red probe on the positive post of the coil. Place the black probe on the negative post. Your reading should be between three and four ohms. Measure the resistance of the secondary winding.
Insert a spark tester into the wire and attach the tester to ground. Remove the fuel pump fuse. Refer to the article Fuse Box Information for fuse locations. Crank the engine and watch for spark. If spark is consistently present, the problem most likely lies with the spark plugs and you should continue to Step 2.
What to do if your Harley Davidson won’t start?
Harley Davidson Sportster: Why Won’t My Bike Start? 1 Test your starter. Refer to Step 4 of the article Electrical Diagnostic Guide for information on starter testing. 2 Check for fuel. If your bike cranks but doesn’t start, the first thing to check is the fuel supply. 3 Check for spark.
What should the current be on a Harley Davidson starter?
In addition to the starter current draw test, you can measure the voltage at the wire connected to the starter solenoid from the ignition switch. With the ignition in the on/run position and the button pressed, 12 volts should be present at this wire.