Why is the battery on my electric scooter not working?
If the battery is not charging correctly or believe it or not TO MUCH charge is going into it then that can cause problems. Remove the battery completely from the bike. Kick start it and see if it runs fine. Although a battery can read 13 volts doesnt mean the battery is in good condition.
Is it possible to charge a scooter that won’t move?
If your scooter battery is showing as fully charged on the battery charger and the battery gauge on the scooter is also showing the battery as fully charged but the scooter won’t move under its own power, please continue reading this article: 1. Confirm that the battery charger is not connected to the scooter. 2.
Why does my scooter not start at 100 psi?
If it’s 100 psi or less there’s likely and engine problem (bad valve, bad piston, failed piston rings) which will need the engine taken apart to find. Probably the most common problems are a dead battery or carburetor problems due to bad adjustment or build up of gummy deposits.
What to do if your scooter won’t turn over?
Check your owner’s manual to make sure that you are doing all you need to to complete the electrical circuit which enables it to start. If the scooter doesn’t turn over when you’ve done all the required operations, there’s an electrical problem with the battery. Make sure the battery is charged. If it is, make sure the fuse hasn’t blown.
What causes a scooter to have power but not start?
Check the Engine Ignition and Fuel System: In most cases, the problem with a scooter not starting but with power is caused by an issue with the engine; either a bad spark plug wire, bad plug or a fuel system problem.
Check your owner’s manual to make sure that you are doing all you need to to complete the electrical circuit which enables it to start. If the scooter doesn’t turn over when you’ve done all the required operations, there’s an electrical problem with the battery. Make sure the battery is charged. If it is, make sure the fuse hasn’t blown.
What should the voltage be on my scooter?
It should be somewhere in the region of around 10 or 20 ohms. If it’s an open circuit, it’s burned out and will need to be replaced. If it seems to be OK it may be stuck, or the wiring to it may have a problem. Check to see that it’s getting voltage.
What to do if choke on scooter wont start?
If the automatic choke is OK, the starter cranks the engine, there’s gas and there’s a spark then there may be an engine problem. You need to check the cylinder compression. You need a compression tester to do this. It screws in instead of the spark plug and measures cylinder pressure.