How do you change a Throwout bearing in a car?
When and if you are changing the clutch, change the throwout bearing also. Replacing a throwout bearing is simple and can be accomplished by any do-it-yourself mechanic. Drive the car up on the wheel ramps and set the parking break. Jack up the rear of the car using floor jack and place on jack stands.
When to replace a release bearing on a flywheel?
Inspect the pressure plate for any scoring, grooves and chips. Also, inspect the flywheel for any rivet grooves, warping or gouging. Surfaces should be smooth. Make sure all teeth on the flywheel are also in good shape. At this point, inspect the release bearing and replace it if worn. Check the pilot bearing for wear and replace if necessary.
How do you replace clutch bearing on Harley?
A large socket will work well depending on the thickness of its outer wall. Press in straight until bottomed. Once resistance is felt, do not try pressing any further, you will break the basket. After the Harley clutch bearing is fully seated, inspect it for any binding or rough feel.
What does a throw out bearing on a clutch do?
The throwout bearing is a small bearing that assists in the disengagement of the clutch. The bearing allows the clutch to smoothly operate within the gear box and is essential for proper clutch function.
How do you replace a throw out bearing on a pushrod?
Remove the retaining clip of the pushrod assembly with a pick tool. This will also release the two thrust washers located just behind the retaining clip. Remove the throw out bearing. Insert a new one into the same slot. Reinstall the two thrust washers and the retaining clip you previously removed. Tighten the clutch cable adjuster with a wrench.
Where is the throw out bearing on a Harley Davidson?
The throw out bearing — otherwise known as the pushrod bearing — is located just inside the transmission clutch release cover on the lower right-hand side of your Harley-Davidson. Replacement is rarely necessary, as it does not wear easily.
When do you change the throw out bearing on a car?
The bearing allows the clutch to smoothly operate within the gear box and is essential for proper clutch function. When and if you are changing the clutch, change the throwout bearing also. Replacing a throwout bearing is simple and can be accomplished by any do-it-yourself mechanic. Drive the car up on the wheel ramps and set the parking break.
When to change the bearing on a Harley Davidson?
We suggest changing this bearing every time you are in this area. If your transmission has high miles, or has had “a hard life” due to aggressive riding; consider replacing your door bearings and Harley throw out bearing as preventive maintenance.