How to change the fault code on a Yamaha motorcycle?
Turn off the ignition, the engine stop button to put in the ON position. 2. Disconnect the fuel pump connector. 3. Simultaneously press SELECT + RESET on the dashboard and not let go. 4. Turn the ignition switch (button still hold) and wait for about 8 seconds until the dashboard inscription “dIAG”.
How to check a Yamaha er-3 fault code?
Er-3 – it is impossible to consider the testimony from the ignition module; Login process in diagnostic mode: 1. Switch off ignition. Disable button Start / Stop Engine (red on the right panel). 2. Press both buttons on and keep them tidy. 3. Turn the ignition, hold the button after the ignition is about 8 seconds.
How to turn off diagnostic mode on a Yamaha?
Login process in diagnostic mode: 1. Switch off ignition. Disable button Start / Stop Engine (red on the right panel). 2. Press both buttons on and keep them tidy. 3. Turn the ignition, hold the button after the ignition is about 8 seconds. 4.
Why does my Yamaha Thundercat rev counter go loopy?
Could be that you didn’t notice it go to 8000rpm or 3000rpm as it go from there to 0 back to proper engine speed. the only rev code that has to do with fuel is as below may be as you were very low on fuel it may just picking up a fault that isn’t showing when full. hope this helps. Fuel level warning system has an open circuit somewhere.
Why does my rev counter not show up?
This post is not being displayed . Could be that you didn’t notice it go to 8000rpm or 3000rpm as it go from there to 0 back to proper engine speed. the only rev code that has to do with fuel is as below may be as you were very low on fuel it may just picking up a fault that isn’t showing when full. hope this helps.
Turn off the ignition, the engine stop button to put in the ON position. 2. Disconnect the fuel pump connector. 3. Simultaneously press SELECT + RESET on the dashboard and not let go. 4. Turn the ignition switch (button still hold) and wait for about 8 seconds until the dashboard inscription “dIAG”.
Er-3 – it is impossible to consider the testimony from the ignition module; Login process in diagnostic mode: 1. Switch off ignition. Disable button Start / Stop Engine (red on the right panel). 2. Press both buttons on and keep them tidy. 3. Turn the ignition, hold the button after the ignition is about 8 seconds.
Could be that you didn’t notice it go to 8000rpm or 3000rpm as it go from there to 0 back to proper engine speed. the only rev code that has to do with fuel is as below may be as you were very low on fuel it may just picking up a fault that isn’t showing when full. hope this helps. Fuel level warning system has an open circuit somewhere.
This post is not being displayed . Could be that you didn’t notice it go to 8000rpm or 3000rpm as it go from there to 0 back to proper engine speed. the only rev code that has to do with fuel is as below may be as you were very low on fuel it may just picking up a fault that isn’t showing when full. hope this helps.