Why does my Arctic Cat 400 have no spark?
I know on the 650H1s there was a problem with the magnetic pickups on the flywheel and the firing sequence would either be off or no existent. That is a big project to check that so I would start with some of the simple stuff first. Try cleaning the ground wire from the engine.
How to start an ATV that wont start?
1 Remove the spark plug from the cylinder-head and connect it to the spark-plug wire or ignition coil. 2 Grab the plug wire and hold the plug about 1/8th of an inch away from the cylinder head. 3 Activate the starter. 4 As the motor turns, you should see repetitive bright blue spark arching from the spark plug to the cylinder head.
Where do I Check my Arctic Cat 4×4?
Check under the plastics for areas where the wiring harness may be rubbing and shorting out. Very common where the harness goes from the fuse block around the frame in the rear of the quad. For that issue I would check the front harness where it crosses over the support.
Why is my ATV not getting a spark?
You will find the proper steps for troubleshooting an ATV that is not getting a spark further down this post. If the spark plug is still dry after cranking the engine for a few seconds, you know that fuel, for some reason, is not getting to the cylinder.
1 Remove the spark plug from the cylinder-head and connect it to the spark-plug wire or ignition coil. 2 Grab the plug wire and hold the plug about 1/8th of an inch away from the cylinder head. 3 Activate the starter. 4 As the motor turns, you should see repetitive bright blue spark arching from the spark plug to the cylinder head.
Why is my 4×4 actuator not working?
Here is what is happening when i start my prowler the actuator automatically starts whining no matter if in 2wd or 4wd. 4×4 is not working of course. So for the time being i just unplugged.
Where is the solenoid on an ATV starter?
The solenoid is usually located near or on the starter. Put your multimeter to DC Voltage. The red lead goes to the battery (red) side of the solenoid. The black lead goes to ground. You should get a voltage reading of 12V or more.
You will find the proper steps for troubleshooting an ATV that is not getting a spark further down this post. If the spark plug is still dry after cranking the engine for a few seconds, you know that fuel, for some reason, is not getting to the cylinder.