Does a Yamaha Grizzly have a belt?
A Grizzly YFM700 drive belt change can be done with just a V-belt replacement part and a handful of basic tools. Here’s how to do it on your Yamaha Grizzly ATV.
What is the CV boot on a Yamaha Grizzly?
NOTE: The front CV boot sets for the Yamaha Grizzly are slightly different from one another. The CV boot set (double offset joint) is for the outer CV joint while the CV boot set (ball joint) is for the inner CV joint. Step 1. Remove the front wheel and the central dust cap beneath it.
Can a CV joint kit be used for a boot?
We offer both complete CV Joint kits that include a new joint, boot, clamps, and lubricant, and boot kits that come with clamps and lubricant. If a torn boot is found in time before the CV Joint is damaged, then a boot kit can be an economical and time saving repair alternative.
Can a CV boot be replaced with a new axle?
If no noise is present and only the CV boot is broken, you can replace just the CV boot. Tip: Before you install a new axle, check the CV joints (even when the boot is broken) and see if they are worth saving. If you need to replace the CV axle completely, the new CV axle will come with the boots already installed.
How do you install a new CV boot?
Step 2: Install the new boot. CV boots come with pre-cut grooves that you just need to open and install the boot over the axle area. Once it is over the axle area, apply the glue supplied with the boot kit and stick both ends of the boot together. As soon as it dries up, the glue becomes as flexible as rubber.
NOTE: The front CV boot sets for the Yamaha Grizzly are slightly different from one another. The CV boot set (double offset joint) is for the outer CV joint while the CV boot set (ball joint) is for the inner CV joint. Step 1. Remove the front wheel and the central dust cap beneath it.
Can a broken front wheel drive boot be replaced?
This Instructable will show how to replace a broken CV boot on a front wheel drive vehicle without disassembling it or replacing the entire shaft. This guide is an inexpensive way to repair the boots only, but if the boots have been torn for a while then the axle bearings may be worn out and the entire axle may need to be replaced.
What should I do if I need to replace my CV boot?
The entire steering knuckle (what the wheel, brake disk, brake caliper, and shock/spring system are mounted on) should now be free enough to pull outward. Move it out just enough to remove the axle from the splined hole. Move to the next step if only replacing the boot.
What’s the difference between CV boot and ball joint?
The CV boot set (double offset joint) is for the outer CV joint while the CV boot set (ball joint) is for the inner CV joint. Step 1. Remove the front wheel and the central dust cap beneath it.