How fast will a 2012 John Deere Gator go?
The 825i can top out at speeds of 44 mph with a carrying capacity of 1400 pounds, which is practically unheard of in the XUV class. Deere is really aiming for the outdoor enthusiast with this launch of the some of the most exciting Gator XUV’s they’ve ever produced.
What kind of engine do you need for a John Deere Gator?
Replace by ordering AM133570 Short Block New 10 HP FE290D John Deere Gator Complete Replacement Engine for a 4X2 Gator Utility Vehicle as well as CX Gators This Kawasaki air cooled engine comes complete, with new carburetor and new starter. This engine is ready to set in your gator.
Where is the primary clutch on a John Deere Gator?
The clutch on the engine is the primary/drive clutch. The driven clutch is located on the transmission. You can’t really adapt your clutch to the straight engine shaft without a fair bit of machining and making an adapter. Much easier is to get a new primary clutch with a straight bore and keyway.
How to lower gear ratio on John Deere Gator?
For example if your machine is heavily loaded down you can pick a spring with a bigger second number which will make the clutch stay at a lower gear ratio longer. If you want your clutch to engage at a lower rpm then pick a lower first number.
Where can I rebuild an old Gator engine?
Another option I discovered was Precision Engineering stl in Missouri. They have a website, as well as ebay store and clearly a ton of experience with these little motors. You ship them your engine and they rebuild the entire thing. top to bottom and it gets turned around in a week or so.
Can a Honda engine be replaced in a John Deere Gator?
Much easier is to get a new primary clutch with a straight bore and keyway. Several years ago I replaced the stock Briggs in my Gator which had a tapered shaft. The new Honda engine had a straight shaft with a keyway.
The clutch on the engine is the primary/drive clutch. The driven clutch is located on the transmission. You can’t really adapt your clutch to the straight engine shaft without a fair bit of machining and making an adapter. Much easier is to get a new primary clutch with a straight bore and keyway.
For example if your machine is heavily loaded down you can pick a spring with a bigger second number which will make the clutch stay at a lower gear ratio longer. If you want your clutch to engage at a lower rpm then pick a lower first number.
What was the name of the Kawasaki pony truck?
This new creation was named the “Pony Truck” and was nicknamed the four-wheeled three-wheeler. Three Rocky Mountain Kawasaki (RMK)—a distributor of KMC—employees, sketched their ideas out with a simple concept in mind: build a vehicle with four wheels that could carry two people and heavier loads than an ATV.