How much horsepower does a 1986 Honda Gold Wing have?
Honda GL 1200 Gold Wing Aspencade
| Make Model | Honda GL 1200 Gold Wing Aspencade |
|---|---|
| Starting | Electric |
| Max Power | 70.1 kW / 94 hp @ 7000 rpm |
| Max Power Rear Tyre | 62.6 kW / 83.9 hp @ 7250 rpm |
| Max Torque | 104.9 Nm / 10.7 kgf-m / 77.4 lb-ft @ 5500 rpm |
What is a 1986 Honda Gold Wing worth?
Values
| Excellent | $4,845 |
| Very Good | $3,035 |
| Good | $1,405 |
| Fair | $585 |
| Poor | N/A |
Are there any problems with the Honda Gold Wing?
Apparently, “1200’s are great but 84/85’s had rear wheel failures (due to) bad machining from the factory. As well as other little problems (nothing earth shaking though).” 1984 and 1985 Gold Wings do, in fact, have ignition problems.
When did Honda gl100 Aspencade come out?
There was the the first gen GL1000 model from 1974 – 1979, then the GL1100 model from 1980 – 1983 which introduced both the GL100 Interstate (’81) and the GL100 Aspencade (’82). The third gen GL1200 that was one of two generations solely manufactured in the US from 1983 – 1987.
When did the Honda Gold Wing 5 Gen come out?
The first few fifth gen models (from the first GL1800 in 2001 to the ’04/’05) where the first years of a generation that introduced a new aluminum frame borrowed from the CR motocross bike series. There was a massive recall due to the frame cracking.
What’s the idle speed on a Honda Goldwing?
While in gear, the bike seems to run ok and the engine will spin at seemingly normal speed (cruising at 35mph in second gear around 300rpm or so). But, the bike slightly accelerates on its own without opening the throttle and will hold speed for the most part unless the brakes are pressed.
Why does my Honda Aspencade run rough at idle?
If the engine still runs rough at idle but decently at higher rpm like after you adjusted the idle screw, it’s probably not just a bad fuel pump. It may be dirty pilot or slow (idle) jets in the carb, including the seats and passageways, which means other stuff inside there is dirty.
Where is the throttle stop on a Honda Aspencade?
As Eric says, to lower the idle rpms you back out the idle adjustment screw (throttle stop) from the right hand side. It’s right between the carb bodies. If you want to fix it up, it’s worth buying the right Clymer manual for it.