Is there an ECU fault on my Honda CBR XX?
There is NO ECU fault recorded. It appears to be speed/engine rev related as at idle it does not illuminate. At increasing speeds/revs it glows brighter – after 30-60 minutes and with high beam (night riding) it glows its brightest.
When to use fi light on Honda CBR XX?
When the motorcycle is on its side stand and the is running below 5000 revs the FI light will flash, the pattern of the flashes indicating the code for the fault the ECM has identified. If the engine can be started, place the motorcycle on its side stand and then start the engine and allow it to idle.
What happens when you reset the ECU on a Honda?
After you install aftermarket parts, resetting the ECU will help your car’s computer “learn” and accommodate the new parts. Sometimes a faulty check engine light may appear, so resetting the ECU can make it go away.
How do you take cover off Honda ECU?
Remove the cover on the fuse box by pulling the tabs outward and lifting up. Set the cover aside. Figure 1. Locate and remove the cover on the fuse box.
How much does a 2001 Honda CBR 929rr cost?
I HAVE 100% FEEDBACK, SO AS I SAID, BUY WITH CONFIDENCE. FULL COST OF THE $3500 COMES WITH A 30 DAY WARRANTY, AS I HAVE NO WORRIES AND NEITHER SHOULD YOU. THE UPGRADES AND MODIFICATIONS: THIS BIKE IS CUSTOM PAINTED ALL BLACK, AND WAS DISASSEMBLED AND EACH PIECE PAINTED BY HAND WHICH IS SHOWN IN THE PICS, HOW IT WAS STRIPPED DOWN.
What kind of swingarm does a CBR 929rr have?
UPGRADES: rear rim is off a CBR1000 (much lighter), also comes with the stock rear rim w/ with tire too!swingarm is from a CBR954 (lighter and stronger)swingarm and frame sliders addedswingarm extension added.
What’s the book value of a Honda 929rr?
Book value on a standard 929rr is around 4500. So the price has been adjusted more than fair for the minor cosmetics, if you have any questions please contact me. Immediate deposit is due upon purchase. Buyer is responsible for pick up or shipping.
Why is the speed sensor on my Honda CBR XX not working?
Well, I finally got hold of some replacement clocks after so long, so you can imagine my disappointment when I put them on, wired them up, and found them to be exactly the same as the previous set i.e., speedo doesn’t move at all and revcounter reads low (limiter hits at about an indicated 6-7000rpm). Bugger.
Where does the fault code go on a Honda CBR XX?
The engine control module ( ECM ) will store the relevant fault code in its memory and this code can be read as follows using the self-diagnostic mode of the ECM. While the engine is running and the motorcycle is being used, the FI light will come on and stay on.
How to start a thread on cbr1100xx.org?
Start a thread with your name and board nickname in the topic. Where has she been? Where will she go next? What state laws are being broken? Discuss mechanical topics related to the XX such as maintenance, repairs, and synthetic oil flame wars.
When the motorcycle is on its side stand and the is running below 5000 revs the FI light will flash, the pattern of the flashes indicating the code for the fault the ECM has identified. If the engine can be started, place the motorcycle on its side stand and then start the engine and allow it to idle.
Where to post your CBR1100XX board photos?
General discussions about the CBR1100XX, riding, posers, squids, and beer. A place for members to post their photos and personal information. Start a thread with your name and board nickname in the topic.