How do you drain the gas tank on a Polaris Ranger?
Just drill a small 1/8″ or so hole and drain. When done just plug it with a self tapping screw. I’ve done this more than once on metal fuel tanks and think it would work just fine on a Ranger tank.
How do you drain the gas on a Yamaha Grizzly?
Switch petcock to off. Pull fuel line from carb and drain the small amount in the hose into a fuel safe container (glass jar). Drain carb float bowl before removing carb from machine cause you always end up dumping it out by accident.
How do you drain a Rzr gas tank?
That said there are really only three ways to drain the tank. 1) Remove the tank and dump the fuel out, a major PIA. 2) Siphon the fuel out, remember water is heavier than fuel so get the hose to the lowest part of the tank. – best way.
What’s the best way to drain a gas tank?
Method 2 of 2: Draining a gas tank using the fuel tank drain plug 1 Basic set of hand tools 2 Drain pan 3 Jack and jack stands 4 Safety glasses 5 Shop rag (to wipe up any potential spills) 6 Wood blocks or tire chocks 7 Note Not all vehicles will have a drain plug on the fuel tank. Before beginning be sure to research your specific… More …
How long does it take to drain a fuel tank?
Continue to pump the hand pump until all of the fuel is drained and you can no longer see fuel moving through the tubing. This may take a bit of time, depending on the amount of fuel that needs to be drained. Step 4: Dispose of or store the fuel.
How do you drain fuel tank on Polaris ATV?
Put a small piece of hose on the vent barb and connect to pump outlet. Remove 2 tank bolts . Remove top of pod/cluster. Remove screws holding lower part of pod on handle bars and let it hang. Lift, tilt, twist, wiggle and pull the tank out.
Is there a drain plug on the fuel tank?
Note Not all vehicles will have a drain plug on the fuel tank. Before beginning be sure to research your specific vehicle to see if it indeed does have a drain plug. Step 1: Drive the vehicle until the fuel is as low as possible. Similar to Method 1, Step1, this will cut back the amount of draining that will need to be done, saving time and energy.
1. Take the fitting off of the engine end of the fuel line. 2. Place the vessel for receiving the fuel beside the boat at a lower level, like on the ground. 3. Put the end of the fuel line in the receiving vessel. 4. Pump the primer bulb to start syphon action.
Put a small piece of hose on the vent barb and connect to pump outlet. Remove 2 tank bolts . Remove top of pod/cluster. Remove screws holding lower part of pod on handle bars and let it hang. Lift, tilt, twist, wiggle and pull the tank out.
Is there an anti siphon valve on a gas tank?
Yes, you are correct in your thinking but so is JB. The anti-siphon valve is primarily there to stop the flow of out of the tank should there be a fuel leak between the motor and the fuel tank. The anti-siphon valve uses a small spring loaded ball.