How much is a 2008 Dyna Glide worth?
Values
| Suggested List Price | Low Retail | |
|---|---|---|
| Base Price | $13,650 | $3,790 |
| Options (Add) | ||
| Total Price | $13,650 | $3,790 |
Why is my Harley Davidson Dyna Glide not starting?
If your battery voltage and connections are in good condition, but your engine is still refusing to turn over, the problem may be in the starter circuit. Perhaps the easiest place to begin is at the starter solenoid on the right side of the motorcycle.
How do you reset the turn signal on a Dyna Glide?
Press left turn signal switch once, and light will flash a number of times to indicate an error code. There is 1.5 seconds between flashes to indicate 1st and 2nd digit of codes and four second pause between codes. Press and hold left switch down for five seconds, and light will flash twice to indicate the TSSM is reset. Turn ignition to off.
Where is the starter relay on a Dyna Glide?
Starter solenoid electrical connections. Another component to inspect is the starter relay, which is located in the electrical fuse box underneath the side cover on the left side of the motorcycle. Relays have the potential to go bad and prevent high current from reaching the starter.
What should the voltage be on a Harley Davidson Dyna Glide?
Use a voltmeter to measure the available voltage at the battery. A battery that is 100% charged will have approximately 12.6 volts, whereas a battery with a 0% charge will read 11.8 volts or lower. If your battery is low, charge the battery on a setting no higher than five amps for a few hours.
If your battery voltage and connections are in good condition, but your engine is still refusing to turn over, the problem may be in the starter circuit. Perhaps the easiest place to begin is at the starter solenoid on the right side of the motorcycle.
What did Harley do to fix the problem on the newer Motors?
What did Harley do to fix the problem on the newer motors? On the 2007 and later motors, hydraulic cam chain followers are now used to get rid of the stiff spring that put too much pressure on the followers rubbing on the cam chain.
What to do if your Harley won’t start?
The Harley service manual suggests to check the electrical connections at the ECM and CKP, as well as check the resistance of the ignition coil before replacing the CKP sensor. That being said, a large number of Dyna owners who have had trouble starting their bikes reported that replacing the CKP sensor immediately cured the problem.
Starter solenoid electrical connections. Another component to inspect is the starter relay, which is located in the electrical fuse box underneath the side cover on the left side of the motorcycle. Relays have the potential to go bad and prevent high current from reaching the starter.