Can you check fuel pressure with a compression test kit?
Fuel pressure can be done with a 100psi 3″ or 4″ gauge with good accuracy. The compression tester usually will give you enough info that you can decide if you have a problem and need to go find the correct test equipment though. It does require a bit of clairvoyance as well.
What kind of engine does Arctic Cat Prowler have?
It`s an 06 /700 Burnt orange with a Suzuki engine . I only have 1,5 volts to the injector ? I get the initial pulse when turning the key on .
What kind of fuel pump does Arctic Cat have?
There is 18 miles I hace a 2007 artic Cat 700, last summer a new fuel pump was… I have a 2010 Artic Cat Prowler 550xt that will not rev. We I have a 2010 Artic Cat Prowler 550xt that will not rev. We have changed the Stator, the CDI box and checked the compression, fuel pump, … read more Continue with my question. Arctic cat 700 HDX. We have
Where is the IAT sensor on my Arctic Cat Prowler?
The IAT sensor is usually located in the side of the air box or intake tube before the throttle body. Ok I got the new map sensor pit on and reset the code. I don’t have any codes that come up at this time.
What is the EFI code on my Arctic Cat Prowler?
Turn the ignition switch to the ON position and read the error code on the LCD. Refer to the following ECU Error Code List to identify the specific problem area. NOTE: Each of the following numerical codes will have a two-letter prefix.
What kind of carburetor does Arctic Cat Prowler have?
I have a almost new 2008 Arctic Cat Prowler XT 650 H1 Ca with a, not Electronic Fuel Injection. When it is “cold\\ ,”Prowler: carburetor, not Electronic Fuel Injection..occurs..weather… 2008 arctic cat prowler.
When do I get my Arctic Cat fuel injector?
Your package should arrive between Thursday June 10th and Thursday June 17th with Standard Shipping. Need it Faster? Contact us. Please note this item is not a vehicle. The image will only represent what the item looks like on the vehicle if shown.
The IAT sensor is usually located in the side of the air box or intake tube before the throttle body. Ok I got the new map sensor pit on and reset the code. I don’t have any codes that come up at this time.
Turn the ignition switch to the ON position and read the error code on the LCD. Refer to the following ECU Error Code List to identify the specific problem area. NOTE: Each of the following numerical codes will have a two-letter prefix.