What kind of regulator does a Harley Davidson use?
The standard Harley regulator uses an electrical component in it called an SCR, silicon controlled rectifier, which is a little electrical switch. When the regulator sees your voltage climbing to high to the battery it shorts the stator wires to ground, which kills all the output from that leg of the stator.
Why is the regulator on my Harley stator not working?
The regulator protects the battery voltage and when the battery voltage climbs too high it shuts off current to ground and bleeds it off as heat. That is what the heat fins on the regulator box are for, to dissipate the heat. If the regulator did not monitor the voltage to your battery it would destroy it.
What kind of motor does a 1974 Harley Davidson Sportster have?
Titled as a 1975 Harley Davidson, Has a 1974 HD sportster “ironhead” motor with VIN also appearing on title. The frame is a true rigid frame of unknown origin. It is molded, and straight. Goes down road with no hands. Frame has 34-36 degree rake. Front end is a late model HD wide glide with billet triple trees.
How many miles does a 1975 ironhead Sportster have?
1975 Harley Sportster 1000 XL ironhead with clean title, 23,873 miles matching Frame and motor numbers 3A41217H5 in fairly nice shape just needs some bringing back to life.
How to replace the regulator on a Harley Davidson Sportster?
Install new regulator, using dielectric grease on the surfaces where the regulator bolts to the frame. Tighten screws securely, using star washers on both sides. Figure 1. Regulator location in front of motor.
How to replace clutch on Harley Davidson Sportster?
Heat the crank and clutch bolts to melt the red Locktite installed by the factory. Remove the crank sprocket nut with a 1-1/8″ socket, breaker bar, and long pipe. Or, you can use an air impact gun if you have one.
Why is my Harley Davidson Sportster not charging?
The vibrations and heat from the motor can and will cause these electrical components to fail occasionally, but fixing them is not hard once you know how. This article applies to the Harley Sportster (1994-2016). Your bike’s charging system should be putting out 13.5 to 14+ volts to the battery when the motor is running.
What kind of hinge does a Harley Davidson Sportster use?
A 4″ door solid brass hinge works perfectly, and brass won’t damage steel sprocket teeth. The angle of the tool depends on whether you are loosening or tightening the bolt. Use your judgement to determine which way prevents rotation. Heat the crank and clutch bolts to melt the red Locktite installed by the factory.