Can you convert motorcycle drum brakes to disc?
Besides swapping the carbs for fuel injectors, you can replace the vintage ignition system with a newer design. You can even turn a classic motorcycle into an electric one, with enough effort. So, can you replace the drum brakes on a vintage motorcycle with discs? In short, yes.
What kind of disc brake does a Honda CB have?
Overview: One of the major things that separates the CB360 from the CL and CJ360’s as well as the CB350 is the introduction a front disc brake. This Tokico single piston unit first showed up on the 1974 “G” version, however it became the standard for the CB’s during production.
Can a Honda CB 750 be converted to dual disc brakes?
We are going to demystify the Honda CB 750 Dual Disc Brake conversion and make it possible for you to do this modification to your bike and greatly improve your stopping power. We would like to thank Ben Hiles for providing this information. 1- caliper arm (make sure you have the correct one as there are two different kinds you can have.
What should I do to my front disc brake?
Lubricate the pivot pin on the caliper mounting arm as it’s typically seized; adjust the caliper drag screw accordingly. Lightly sand both sides of the rotor with some 80 grit sandpaper to remove the glaze prior to installing fresh pads.
Where can I find brake hoses for a Honda CB 450?
If you’re working on a 450 model you can find the brake hoses for that model here. If your brake hoses look the picture to the right it’s time to change them out. Always use fresh brake fluid from a sealed container. Lubricate the pivot pin on the caliper mounting arm as it’s typically seized; adjust the caliper drag screw accordingly.
Overview: One of the major things that separates the CB360 from the CL and CJ360’s as well as the CB350 is the introduction a front disc brake. This Tokico single piston unit first showed up on the 1974 “G” version, however it became the standard for the CB’s during production.
We are going to demystify the Honda CB 750 Dual Disc Brake conversion and make it possible for you to do this modification to your bike and greatly improve your stopping power. We would like to thank Ben Hiles for providing this information. 1- caliper arm (make sure you have the correct one as there are two different kinds you can have.
Lubricate the pivot pin on the caliper mounting arm as it’s typically seized; adjust the caliper drag screw accordingly. Lightly sand both sides of the rotor with some 80 grit sandpaper to remove the glaze prior to installing fresh pads.
How much stopping power does front disc brake have?
However, the front brake provides 80% of the stopping power on your bike, so let’s make sure it is working at its full potential. There are three areas to address: Master Cylinder, Caliper, and Brake Hoses.