Where is the oil tank drain plug on a Harley Davidson?
Find the oil tank drain plug on the underside of the frame, on the right side near the swing arm to the rear. Slide a drain bucket underneath the plug.
Where is the oil filter on a Harley Davidson?
Remove the oil filter which is located on the lower left, forward portion of the engine. Use the oil filter wrench to remove the filter, and allow any oil to drain. Remove the new filter from the box. Locate the black seal on the side that screws into the motorcycle; lubricate this seal by rubbing a small quantity of used motor oil into the seal.
Can you change the oil on a 2007 Harley Davidson?
Even though motorcycles are remarkably easy to work on because of their easily accessible mechanical parts, for some reason getting a motorcycle serviced can be more expensive than doing so with an automobile. Fortunately, home mechanics can easily change the motor oil on a 2007 Harley-Davidson in less than an hour.
How do you clean oil out of an engine?
Slide a drain bucket underneath the plug. Use a socket wrench to remove the bolt, and allow the motor oil in the engine to drain. Replace the drain plug, and use shop rags to clean any oil that spilled on the floor, engine or frame. Remove the oil filter which is located on the lower left, forward portion of the engine.
Where do you drain oil on a Harley Davidson?
Drain the transmission oil. The transmission drain plug it centered directly above the shock absorbers. Because both the engine and transmission drain plugs are so close to each other, they can easily be drained simultaneously into the same drain pan. Stand your Harley upright.
Where is the transmission drain plug on a Harley Davidson?
The transmission drain plug it centered directly above the shock absorbers. Because both the engine and transmission drain plugs are so close to each other, they can easily be drained simultaneously into the same drain pan. Stand your Harley upright.
How to do an oil change on a Harley Davidson Twin Cam?
Screw the filter on until the gasket makes contact with the oil filter housing, then turn it another 3/4 or a turn. This must always be done by hand. Never use a wrench to tighten an oil filter. Drain the primary chain case. This is the beginning of the final leg of your oil change. Find the drain plug in the bottom side of the chain case.
How much oil do you put in a Harley Davidson engine?
Fill the engine oil tank. The engine oil capacity is 3 quarts (2,800 ml; 100 imp fl oz). Most likely there is still oil left over in the sump, so fill it with 2 quarts (1,900 ml; 67 imp fl oz) and check the dip stick. Add oil until the oil level is between the low and high indicators on the dip stick.