Why does my motorcycle make no noise when I turn it on?

Why does my motorcycle make no noise when I turn it on?

Depending on how low your battery is, if there is some voltage left you may be able to turn the key as well as turn on your blinker, but turning it over is slow and sluggish. If your battery is completely dead, you motorcycle will not make any noise at all when you try to start it.

Why is my motorcycle clicking when I try to start it?

The solenoid is a little magnet and when you turn the key, it shoots out a small gear that the magnet polarizes. Essentially, this gear starts turning which in turn starts rotating the flywheel in the engine. When you turn the key and the battery is dead, you hear the magnet trying to magnetize the gear which is what makes the clicking sound.

Why does my Harley Davidson bike not start?

The battery was fine itself however, the battery was a slightly different size than the Harley battery. This would cause it to shift in the battery housing and cause a poor connection. Then the bike would drain on battery non stop. Thanks for all the help!

What should I do if my motorcycle won’t start?

How to fix it: There is only one fuse that can affect the starting of a motorcycle. Every motorcycle usually has a main fuse which is between 30 to 50 amps (occasionally some bikes will have 20 amps). It is usually located off of the positive battery wire.

Why does my bike make a clicking noise when I start it?

This post is to explain what the noise is and why it happens. The starter motor on a bike uses a lot of power to turn the engine. The starter button cannot handle the current that the starter draws from the battery so a large electric switch called a solenoid is used.

If the reading stays steady, your battery is good to go—and your motorcycle likely has another problem (or a few problems). Fortunately, there are other troubleshooting means that can help determine why your bike won’t start.

The battery was fine itself however, the battery was a slightly different size than the Harley battery. This would cause it to shift in the battery housing and cause a poor connection. Then the bike would drain on battery non stop. Thanks for all the help!

What causes a motorcycle starter to go bad?

A motorcycle starter goes bad usually because of age. Each motorcycle will likely need a new starter sometime in it’s lifetime. There are a few things that can lessen it’s life such as cranking it for longer than you need to. That can cause electrical connections to overheat and melt.

What should I do if my motorcycle battery wont start?

If the reading says anything close to or slightly below 12 volts, charge your battery and try starting your motorcycle again. If it has a really low number, such as 9 volts or below, then you battery is pretty much toast and you’ll need to purchase a new one.

A motorcycle starter goes bad usually because of age. Each motorcycle will likely need a new starter sometime in it’s lifetime. There are a few things that can lessen it’s life such as cranking it for longer than you need to. That can cause electrical connections to overheat and melt.

What’s the problem with my bike not starting?

Bike won’t start, battery is fine I just joined the sight because I really need some help. I am a first time owner and have a 2005 Suzuki GSX600F Katana with 12,000 miles. It has been good to me besides recently. I started it up a few days ago, went to put it in first gear from neutral and it shut off. It would not start up there after.

Why is my push starter not working on my motorcycle?

Also, if the push starter was getting an electrical current and still not working, it would have drained your battery after about 10 tries with no engine turn over. So you most likely just need to replace the push starter.

Bike won’t start, battery is fine I just joined the sight because I really need some help. I am a first time owner and have a 2005 Suzuki GSX600F Katana with 12,000 miles. It has been good to me besides recently. I started it up a few days ago, went to put it in first gear from neutral and it shut off. It would not start up there after.

What happens when you push the start button on a bike?

When you push the button it gives power to the starter to crank the motor. When you push start the bike, with it in gear you crank the motor manually, so check the connection (s) at or around the start button. As for the clutch hmmm does it engage, as in when you pull in the lever does it work as intended?

Depending on how low your battery is, if there is some voltage left you may be able to turn the key as well as turn on your blinker, but turning it over is slow and sluggish. If your battery is completely dead, you motorcycle will not make any noise at all when you try to start it.

Why does my motorcycle not start in cold weather?

The gasoline doesn’t entirely evaporate when it is mixed with air during cold temperatures and therefore combustion doesn’t occur correctly. Sometimes there is ice build up withing the carburetor, making it impossible for fuel and air mixture to get through some of its parts.

Why does my ATV lose power when it gets warm?

“Why does my ATV lose power when it gets warm?” That’s the gist of the question I chose for this week’s addition of the ATV AnswerMan, which is all about a Polaris Sportsman 500 H.O. that just won’t cooperate. I’m trying to fix my brother in law’s quad (Polaris Sportsman 500 H.O.) and can’t seem to figure it out.

What causes the whirring sound on a bad starter?

If the engine is cranking and your vehicle won’t start, then you are probably dealing with an ignition or fuel system problem. But if you don’t hear a cranking sound and the engine won’t start while hearing the noises described above, then you are most likely dealing with a starter problem. What Causes The Whirring Sound On A Bad Starter?

Why does my car make a clicking sound when I start the engine?

This is NOT the sound of a broken starter. Again, this symptom (multiple and rapid clicking sounds and the engine won’t turn over or start) can be caused by a weak battery or loose battery terminals. 3. If you twist the key and you hear the starter motor cranking but the engine won’t start, then this is not the sound of a bad starter.

The solenoid is a little magnet and when you turn the key, it shoots out a small gear that the magnet polarizes. Essentially, this gear starts turning which in turn starts rotating the flywheel in the engine. When you turn the key and the battery is dead, you hear the magnet trying to magnetize the gear which is what makes the clicking sound.

If the engine is cranking and your vehicle won’t start, then you are probably dealing with an ignition or fuel system problem. But if you don’t hear a cranking sound and the engine won’t start while hearing the noises described above, then you are most likely dealing with a starter problem. What Causes The Whirring Sound On A Bad Starter?

This is NOT the sound of a broken starter. Again, this symptom (multiple and rapid clicking sounds and the engine won’t turn over or start) can be caused by a weak battery or loose battery terminals. 3. If you twist the key and you hear the starter motor cranking but the engine won’t start, then this is not the sound of a bad starter.

How to fix it: There is only one fuse that can affect the starting of a motorcycle. Every motorcycle usually has a main fuse which is between 30 to 50 amps (occasionally some bikes will have 20 amps). It is usually located off of the positive battery wire.

What to do if your dirt bike kick start gets stuck?

When attempting to start a dirt bike engine with the kick start and discovering it is frozen, avoid the temptation to kick harder as this can lead to serious damage. Instead, put the engine in neutral and carefully push the kick start.

Why is the spark plug on my motorcycle not working?

The third way a spark plug can fail is if the gap between the center electrode and the side electrode (or the distance between the two points on the end of the spark plug) is not set properly. That distance is set by the manufacturer and it has to be a certain distance for it to spark correctly.