When to reset belt light on Kawasaki ATV?
However, the belt light may stay on after flipping the switch back to “ON”, or it may have come on automatically at 100 hours to get you to return the machine to the dealer for inspection even though the belt switch is not tripped. The following procedures will reset the light if the belt switch is not tripped.
Is there a belt Trip Switch on a Kawasaki 360?
This has been the case with many 360 owners, they found them after looking further. There is a procedure in the Vforce folder for the Vforce to reset the light. The Vforce does not have a belt trip switch. Note: Disconnecting the battery does not reset the light.
Why does my kvf360 reset belt light keep coming on?
Do not turn the ignition on with the CVT cover removed or the KEBC motor will spool out and prevent you from putting the cover back on (unplug the KEBC motor if you do). Note: A poorly connected battery can cause the light to repeatedly come on even if the switch doesn’t flip.
Can a loose belt switch cause power loss?
If the belt switch is tripped, adjust the belt and flip the switch back to “ON” (a loose belt flips it to off). A flipped switch will cause a power loss. See further down page for location of the switch. 2003 650, Prairie 700 and BF650 SRA can also have their belt switches tripped by a loose belt. A tripped switch will cause loss of power.
How do I Reset my drive belt on a Kawasaki ATV?
The information contained in the guide explains how to reset your Drive Belt Check system and/or the Drive Belt Failure Detection System. Models equipped with a Drive Belt Check system may alert you to check your belt by illuminating a light on the instrument cluster.
Do you need to reset the belt light on an ATV?
The belt warning system on your ATV must be PROPERLY reset and should not be disabled or tampered with. This manual will show you how to properly reset it. Don’t get stranded out in the middle of nowhere without the information you need to reset your belt light and get back on the trail.
This has been the case with many 360 owners, they found them after looking further. There is a procedure in the Vforce folder for the Vforce to reset the light. The Vforce does not have a belt trip switch. Note: Disconnecting the battery does not reset the light.
Do not turn the ignition on with the CVT cover removed or the KEBC motor will spool out and prevent you from putting the cover back on (unplug the KEBC motor if you do). Note: A poorly connected battery can cause the light to repeatedly come on even if the switch doesn’t flip.
How do you reset the belt light on a prairie 360?
Cut the key on for about 5 seconds, or untill you see the flashing lights momentarily blink differently. Then cut the key back off. Plug the grey and black plugs up the way they were. Don’t foget to fasten them back up to the frame, if you pulled the strap off of them. Cut the key on to verify the procedure worked.
Where is the belt light reset button on a Kawasaki P650?
Belt light reset procedure for late 2003 and later P650, P360, and BF650SRA. 1. Turn the ignition switch OFF. 2. Disconnect both sets of 5 pin connectors located above the CVT cover. Note: These connectors are located just beneath the shift handle on the right side of the 650; one is black and one is grey.