What to do if your indicator stalk is not working?
On older stalk assemblies it is usually possible to clean up the contacts of the assembly with fine grade wet-or-dry paper or a small nail file. Operate the switch and take a closer look at the contacts to see how they work. You may find that they don’t touch properly – if this is the case, bend the switch contacts so they make a better connection.
When does an off delay timer turn on?
With OFF-delay operation, the output turns ON at the same time as the input and then the output turns OFF when the Timer contacts switch after the set time has expired. The set time is calculated from when the input turns OFF. This name is used because there is a delay between when the input turns OFF and when the output turns OFF.
What does it mean when your indicator light fails?
If the circuit tester illuminates, the wiring to and inside the switch are okay. If the circuit tester fails to light, it indicates a fault either in the switch itself or in the wiring between the switch and the multi-plug.
Which is the best description of a timer?
A Timer is a control device that outputs a signal at a preset time after an input signal is received.
On older stalk assemblies it is usually possible to clean up the contacts of the assembly with fine grade wet-or-dry paper or a small nail file. Operate the switch and take a closer look at the contacts to see how they work. You may find that they don’t touch properly – if this is the case, bend the switch contacts so they make a better connection.
How can I tell if my time clock is working?
If power is coming to the timer motor, you should be able to clearly see the gears moving through the small window. If not, then check the breaker that the time clock is connected to, turn it off and back on again. If no movement still, test the wires coming into the timeclock, to see if power is reaching the time clock.
What are the signs of a power tool not starting?
Similar to a tool that won’t start, check your carbon brushes for any heavy wear or signs of damage. If your brushes are clear, there may be damage to your tool’s commutator or the rest of the assembly. Discoloration, buildup and even melted insulation are signs that these parts are the root cause.
Is there a problem with my Intermatic pool time clock?
The workhorse of the equipment pad, these timer clocks can outlast some of the equipment that they power – but eventually, the workhorse will tire, and need to be retired to pasture – or maybe you can fix it! Here’s some thoughts on how to troubleshoot your pool time clock problems, and fix or repair an Intermatic pool time clock.
How are the wires attached to an indicator stalk?
Refer to the wiring diagram in your service manual to identify the indicator wires. There are usually three wires attached to the indicator switch: one feed wire to the switch and two wires leading from it to feed the right- and left-hand circuits . Look carefully to make sure none of the wires has fallen off or broken.
How to check fault codes DD15 Freightliner Cascadia?
Hold the button until the display shows “faults”. From there it will show you the number of active faults in the system. Again using the black button cycle through the “faults” to observe the SPN and FMI.