Why does the throttle stick on my Honda?
Notice the throttle tends to stick. It doesnt snap back to idle like it should, I commonly have to push down the spring on the right side of the bike (on the carbs) to get the idle back to its lowest setting. They appear to be the original throttle cables on the bike.
How do you adjust the throttle valve cable?
Tip: Consult the owner’s manual for any specifications for your car’s make and model. Adjust the cable by a small increment then have your helper press the gas pedal all the way down and check the cable at WOT. Lengthening the cable will allow the vehicle to shift earlier and the shift will be softer.
Where do you find the throttle linkage on a Honda Accord?
Step 2: Locate the throttle linkage. Before you can make any adjustments, you will need to locate the throttle valve adjustment location and the throttle linkage. Pop the hood and look for the intake piping. Follow the piping to the intake itself. You will find a series of linkages and cables mounted on the intake.
Do you need to return the throttle cable on a 1993 Honda Shadow?
Bike is a 1993 vt1100. Some are ditching the return cable.. The two springs in your carb must return the throttle.. If i were you i will spray some wd40 in the joints, springs and moving partes in the carb..
Where is the idle adjustment screw on a Honda ATV?
Locate the idle adjustment screw behind the recoil starter cover. Twist this screw a few times clockwise to raise the engine speed to a fast rate. Listen carefully to the engine and twist the idle adjustment screw slowly counterclockwise.
Notice the throttle tends to stick. It doesnt snap back to idle like it should, I commonly have to push down the spring on the right side of the bike (on the carbs) to get the idle back to its lowest setting. They appear to be the original throttle cables on the bike.
Bike is a 1993 vt1100. Some are ditching the return cable.. The two springs in your carb must return the throttle.. If i were you i will spray some wd40 in the joints, springs and moving partes in the carb..
Can you return the throttle cable to the original place?
If your pull cable becomes sticky or dirty you can physically return your throttle to the original place without reaching down and finding the carbs and possibly burning your hand. A lot of people are doing away with the return cable and had no problem, but I keep mine in place and in good working order just in case on long rides.