Why is my sled running at 2000 rpm?
Went into a climb and wrench light came on sled dropped 2000 RPM. it was a pretty good hill and couldnt get turned out all the way, dropped to bottom of the hill restarted sled seemed to run good so up the hill again and yet again same out come!
Are there any problems with the snowest sled?
Pulled side panels and hood checked all hoses for tightness put everything back together and pulled the hill with no problems. Turned to pull a chute next to it and 3/4 way up same thing sled appears very hot but never seen a temp light.
What should the idle RPM be on a car?
Your engine should normally get to around 700 RPM after you start the vehicle, depending on the model. If your idle is way off and you have one or more of the problems listed above, then you will want to diagnose the issue right away.
Why does my sled not start after a break?
No lights or codes, when I stopped for a break I opened my side panels to let some heat out, about a minute later coolant started to boil over, the oil vent line melted off and plugged and the side panels had started to melt. The sled would not start after it cooled down. I cut the oil vent line and it started fine.
Went into a climb and wrench light came on sled dropped 2000 RPM. it was a pretty good hill and couldnt get turned out all the way, dropped to bottom of the hill restarted sled seemed to run good so up the hill again and yet again same out come!
Pulled side panels and hood checked all hoses for tightness put everything back together and pulled the hill with no problems. Turned to pull a chute next to it and 3/4 way up same thing sled appears very hot but never seen a temp light.
Why does my car not go over 2K rpm?
In drive won’t go over 30mph & if rpms get to 2k sputters loses power badly. Replaced, IAC,tps, plugs, wires, throttle body, catalytic converter, ignition module, coil packs, fuel pump,filter. It’s like it’s in limp mode. Any help will be appreciated. My car has 140230 miles. My car has an automatic transmission. My car has 140988 miles.
No lights or codes, when I stopped for a break I opened my side panels to let some heat out, about a minute later coolant started to boil over, the oil vent line melted off and plugged and the side panels had started to melt. The sled would not start after it cooled down. I cut the oil vent line and it started fine.