What happens if chain sprocket is damaged?
If the teeth are worn bad enough the chain may not roll off the sprocket as it turns. This could cause the wheel to lock up and result in a uncontrolable skid. The lack of chain tension could also cause the chain to fall off and jam in the drive train. You might ruin the wheel or damage the engine and transmission.
What is the life of chain sprocket?
Generally, a well-cared-for bike will do 20,000 to 30,000 miles with a single chain-sprocket set. However, depending on the chain type, quality, and how you hold your bike can sometimes need replacement after just 5,000 miles.
How much does it cost to replace a chain and sprocket?
Chain and sprockets (front and rear – replace chain and sprockets as a set) is around $200 to replace (not counting labor – maybe an hourish at 50-80/hr). $250 in labor to change chain and sprockets. Sprockets are one of the easiest things to change out on a bike.
How long does chain sprocket last?
Can a new sprocket be used with a new clutch?
3) A new drive sprocket (35205-79) must be used in conjunction with the new clutch gear, (with the new thinner thrust washer), to retain the proper drive sprocket position. Either install a new washer (35216-79) in the old clutch gear (37448-71) or use a new clutch gear (37448-79) which comes with the new washer already installed.
How do you change the sprocket on a Harley Davidson?
The instructions for Baker’s compensator sprocket kit upgrade are straightforward and easy to understand. As usual, Fix My Hog suggests that a factory service manual is also available for reference for the Harley compensator sprocket removal. Bob begins by draining the primary drive oil and removing the outer primary cover.
Can a compensator be removed from a sprocket shaft?
After the bolt is removed, remove the rest of the compensator assembly. None of the assembly will be reused. The next important step is cleaning the sprocket shaft threads.
Why was the transmission sprocket hub width increased?
The transmission drive sprocket hub width was increased .020” to compensate for the clutch gear change. 2) This upgrade was recommended as a replacement for earlier transmissions, especially those with severe shifting service where rounding of the gear teeth is likely to occur. 3)
How to troubleshoot a chain or sprocket problem?
Improper installation of the sprocket or axle. Inspect and correct. Chain casing or bearings are loose. Tighten all bolts and nuts. Excessive or insufficient slack in the chain. Adjust the distance between axles to obtain the proper amount of slack. Excessive worn chain or sprocket. Replace the chain and sprocket with new chain and sprocket.
3) A new drive sprocket (35205-79) must be used in conjunction with the new clutch gear, (with the new thinner thrust washer), to retain the proper drive sprocket position. Either install a new washer (35216-79) in the old clutch gear (37448-71) or use a new clutch gear (37448-79) which comes with the new washer already installed.
How do you change the sprockets on a car?
Refit a new tab washer (if applicable) and do the nut up finger tight. Next, remove the rear wheel and support it against a wall, or rest it sprocket-side-up on an old tyre, and undo the sprocket nuts.
The transmission drive sprocket hub width was increased .020” to compensate for the clutch gear change. 2) This upgrade was recommended as a replacement for earlier transmissions, especially those with severe shifting service where rounding of the gear teeth is likely to occur. 3)