How do you reset the codes on a Polaris RZR 1000?
To reset the ECU, you have to disconnect the battery completely. Then touch your RZR’s wire harness terminals together. This will drain the capacitors and anything else in your ECU that holds a charge, and is a guaranteed method of resetting your Polaris RZR’s check engine light.
Why is my Polaris Sportsman 500 not starting?
First, there may be low battery voltage, and owners should try to recharge the battery to 12.8 VDC. Two other problems may be that there are loose connections on the battery or on the solenoid. In either case, owners should check and tighten all connections. If the engine turns over but will not start, it is possible that the ATV is out of fuel.
What to do with a 2000 Polaris Sportsman 500?
Put some Seafoam in the fuel and run it. Old fuel with alcohol is hard on these carbs. The corrosion will partially plug up the circuits, especially the low speed one. If you are going to let it sit, turn off the fuel and run the carb out before storing. I used to own a 2000 500 also.
What to do if your Polaris Sportsman has mechanical issues?
Also help locals with mechanical issues. Put some Seafoam in the fuel and run it. Old fuel with alcohol is hard on these carbs. The corrosion will partially plug up the circuits, especially the low speed one. If you are going to let it sit, turn off the fuel and run the carb out before storing.
What kind of Lights does a sportsman 500 use?
I have a 2004 Sportsman 500 HO and yesterday the instrument cluster including AWD and high beam light quit working. Low beam lights, fan and winch work fine and atv starts with no problem. Any help would be appreciated…
Why does the speedometer on a Polaris Sportsman stop working?
I have a1998 polaris sportsman 500. The speedometer the all wheel drive and the reverse r.p.m. restrictor have all quit working. Why? … read more I have a polaris sportsman 450. It has about 500 miles on I have a polaris sportsman 450. It has about 500 miles on it and the service light is blinking.
Why is my Yamaha sportsman 500 not working?
Yamaha,Suzuki,Polaris Tec… I have a 2008 Polaris 500 HO Sportsman, but theXXXXXis not working. The machine is like new, so it is probably electronic. All fuses are good. Should I suspect the 4×4..4x4ADC switch? … read more
I have a 2004 Sportsman 500 HO and yesterday the instrument cluster including AWD and high beam light quit working. Low beam lights, fan and winch work fine and atv starts with no problem. Any help would be appreciated…
What to do when the gauges on your Polaris ATV stop working?
Simply put a splice wire between the brown wire at the high beam connector (just shove a bared end of a splice wire into the back of the connector) and to ground and you will be amazed, everything will work. Then just tie in a section of wire from the headlight connector to ground, and it will be fixed.