How do you start a Polaris 500?

How do you start a Polaris 500?

Starting the Engine

1. Position the vehicle on a level surface outdoors or in a well-venti- lated area.
2. Place the transmission in PARK.
3. Lock the parking brake.
4. Turn the fuel valve on.
5. Sit on the vehicle.
6. Do not use the choke if starting a warm engine.
7. If the engine is cold, pull the.
8. If the knob doesn’t stay where.

What to do if your Polaris wont start?

If you don’t hear a clicking then you have to make sure that you have power to the solenoid from the key switch. You can meter it from the thin wire on the solenoid. If you don’t then you have an issue in the switch. b. If yes, then meter the contacts of the solenoid while turning over the key.

What to do with a 2000 Polaris Sportsman 500?

Put some Seafoam in the fuel and run it. Old fuel with alcohol is hard on these carbs. The corrosion will partially plug up the circuits, especially the low speed one. If you are going to let it sit, turn off the fuel and run the carb out before storing. I used to own a 2000 500 also.

What’s the ignition problem on a Polaris trailboss 325?

I’m fixing a 2000 Polaris trailboss 325. There is a problem somewhere in the ignition system. So far I’ve replaced the key switch ,solenoid ,battery ,spark plug and main engine wiring harness. It will start with the key on and jumping the solenoid and will also pull start.

Why is the ignition not working on my Polaris ATV?

The ignition does not need the battery for the engine to run – the battery is for running the starter motor and other DC operated components. Since the lights work and the engine can be stopped, we can presume the key switch is operating correctly and the run/stop switch is working, but the start function is not working.

Why is my Polaris Sportsman 500 not starting?

First, there may be low battery voltage, and owners should try to recharge the battery to 12.8 VDC. Two other problems may be that there are loose connections on the battery or on the solenoid. In either case, owners should check and tighten all connections. If the engine turns over but will not start, it is possible that the ATV is out of fuel.

Put some Seafoam in the fuel and run it. Old fuel with alcohol is hard on these carbs. The corrosion will partially plug up the circuits, especially the low speed one. If you are going to let it sit, turn off the fuel and run the carb out before storing. I used to own a 2000 500 also.

When to see a Polaris dealer for a problem?

If there are defective spark plugs or no spark is going to them, then the spark plugs should be inspected and replaced as necessary. For three other potential problems (a clogged fuel filter, water/fuel in the crankcase or mechanical failure), Polaris recommends that owners see a Polaris dealer.

I’m fixing a 2000 Polaris trailboss 325. There is a problem somewhere in the ignition system. So far I’ve replaced the key switch ,solenoid ,battery ,spark plug and main engine wiring harness. It will start with the key on and jumping the solenoid and will also pull start.